Pump Baby, Variety, Use Segment

click fraud protection

Content of the article:


Vibration pump The kid is made in Russia by several plants. The inexpensive device is used in farms on water supply, as drainage or watering. A characteristic feature of the tool is simple maintenance, low weight and the lowest cost of the segment.

Scope of Pumps

Universal pump is used in farms of various types. Limits the use of the tool only power and pressure. Pump Baby is used for pumping water mixed with sand or silt, but with a small amount of suspension.

Tasks performed using the tool:

  • rising water from a depth of up to 40 meters;
  • pumping in a tank with a height of less than 4 meters, flow into the water supply;
  • watering a plot with an abstraction of water from an open reservoir;
  • drainage buildup of flooded rooms or pools;
  • to create pressure when washing cars, buildings outside, tracks.
instagram viewer

For use in different directions, water intake is provided from below and above. But any pump for trouble-free operation must be supplied with a suction filter and automatic control, protection against engine overheating. Manufacturers of modern models guarantee the work of the equipment for one and a half years. But in the farms can be found pump Baby at the age of 25 years. The first models were more viable. The cost of the pump, depending on the configuration of 1300-2500 rubles.

For continuous year-round use, the vibration pump can be delivered without having calculated the consequences. Despite the rubber gasket, the vibration during operation is transmitted to the walls of the casing, destroying it. Over time, a tool worth a thousand will destroy a well, the cost of which is measured in tens of thousands of rubles.

Device, principle of operation and water pumps

Vibrating pump The kid has a diaphragm chamber as its working unit. The membrane is an elastic jumper. The pump is powered from an AC network with a frequency of 50 Hz. Electromagnetic oscillations with the same frequency affect when the pole is changed to the core, forcing it to perform oscillatory movements in the axial direction. At the same time, the core is connected to the membrane through the float. The increase in the volume of the water chamber creates a vacuum, the water flows. When compressed - squeezed through the valve. Structurally, the water inlet can be above or below. The location of the fence determines the use of the pump.

Read also: Manual Dilder for potatoes

The design of the water pump Kid is simple. But in order for the pump to work for a long time, it is proposed to equip it with automatics: the

  • dry-running sensor, which allows stopping the operation in the event of camera airing or sanding;
  • float switch operating at a given level;
  • power supply voltage regulator;
  • thermostat to prevent overheating of the pump casing;
  • RCD;
  • check valve;
  • pressure gauge;
  • hydroaccumulator.

A snap-in will extend the lifespan, but will add installation cost. In some models, the necessary equipment is installed, and the richer the equipment, the more expensive the pump.

Vibrating Pump The Kid has several modifications. The lower water intake is made on the series Kid and Kid-K.The pump can be used for pumping tanks with moderately dirty water or installed in wells and wells with an internal cross section greater than 100 mm.

Lower water intake means that in some cases the engine can work in airspace and heat up more. Therefore, Baby-K is equipped with built-in overheating protection. When using these devices should consider the possibility of falling into the chamber of a large amount of sand in the lower holes with a small layer of liquid. Therefore, the submersible pump for the well Kid is installed in a meter from the lower boundary of the water receiver on the suspension. When pumping out of the tank there should be a level control, the float switch will not interfere.


For water wells it is better to use pumps with the upper water intake, when the engine is at the bottom, it has the best working conditions. The suction hole takes in clean, not stirred up water suction. With the same technical characteristics, the Kid-M and Kid-3 pumps have a smaller body in cross section. They can be installed in the casing of a smaller diameter.

Read also: Buy an electric cultivator for gardening - speed up tillage

Pump pump specifications:

  • capacity - 432 l / h;
  • head - 4 bar;
  • power consumption - 245 W;
  • weight - 3.5 kg;
  • outer diameter liner - 100 mm;
  • maximum installation depth - 40 m.

Kid-3 has a weight of 3.2 kg, a cross section of 76 mm, while reducing network power consumption to 160 watts. At the same time, it can lift water from a depth of 20 m.

The same category as the pump The Kid belongs to the Brook, a Belarusian manufacturer. The model of the vibrating submersible pump Streamlet -1 corresponds to the Kid-M, with the upper water intake and with protection against overheating. The pump casing is somewhat more massive, 4 kg, section of 98 mm, which allows it to be installed in casing, more than 4 inches.

Streamlet-1M has a lower fence, it allows you to use the tool as a drainage, for draining clean water pools. The cost of the Belarusian pump and its quality does not differ from the Russian model.

Completion and operation of pumps Kid and Stream

When buying a pump, you must first determine where to use the equipment. So, if it is required to supply water from the tank for irrigation, it is better to buy a pump Kid with a lower fence. Then you can almost completely drain the tank. For the use of water for lifting from the depth, the apparatus is more suitable, where the fence is carried out from above. When installed in a well, the vibration pump must be isolated from the walls with rubber cuffs. They quench the vibration, but make it difficult to lower and raise the structure.

Read also: Electric lawn mower - a rating of the best models of proven manufacturers

Water pump The Kid is notable for its instant start. In the factory, the minimum set includes:

  • pump;
  • hoses for watering and raising water from the horizon;
  • inlet filter;
  • spare parts, incl.necessarily valve, piston;
  • connection cable with a single-phase network plug;
  • user manual.

It is better if the product is manufactured at sites in the CIS or in Russia. In a more expensive configuration provides nylon cord for in-depth installation. There is a thermal switch, pressure switch, protection against dry running. The wider the equipment, the more expensive the device.

Proper installation of the pump is important, the working position should be vertical, without distortions. The pump should be fixed with a strong kapron cord, passing it through the grooves. At the same time, a load with a spring should be suspended at the bottom to dampen the vibration. The pump housing is separated from the casing walls by elastic cuffs.

You can never lower a deep-well pump using a wire, it does not dampen, but resonates vibration. This will cause the mount to wear and the pump may fall.

Pumps in this category are not designed for continuous use. Respect for the instrument and repair can extend the service life. After the end of the warranty period, repairs in the workshop will become irrational. But spare parts are inexpensive, simple repair. If the engine is running, the casing is easily disassembled, the installation sequence can be found in the instruction manual.

Universal pump will become an indispensable assistant at the cottage. When leaving, you can grab it with you.

Video review of the pump Kid

https: //www.youtube.com/ watch? V = xRGrPqdjkR4

Cordless chain saw - specifications, models

Cordless chain saw - specifications, modelsReviews

A cordless chain saw combines the virtues of electric power and mobility of a petrol tool. The use of batteries in energy-intensive equipment has become possible with the creation of hi...

Read More
Pump Aquarius, device, model range

Pump Aquarius, device, model rangeReviews

Contents of the article: Versions of pumps Design, principle of operation and application of the pump Aquarius-3 Description of the pump BTsE Aquarius for a pipe of 110 ...

Read More
Cultivator Viking - Model Review

Cultivator Viking - Model ReviewReviews

Contents of the article: The difference between the Viking line of small machinery and models of Viot tillers Video about attachments for the Viking cultivator ...

Read More
Instagram story viewer