~ 1 minute is required to readA small kitchen requires a special approach when choosing a planning solution. The corner option came in handy here, and the pink color of the furniture gives the interior originality and chic. The set is simple, with MDF facades, it perfectly supports the modern style of the interior. The floor is tiled, the ceiling is trimmed with PVC panels.
The design of the kitchen is fully consistent with the style of the people living in the apartment. The main wish of the landlady was the choice of color scheme, photo facade, as well as a small bar counter, which will be a convenient addition to the dining area. Then came the requirements for convenience and functionality. An important point is the maximum use of each centimeter of space, since the kitchen area is only five square meters.
Photo Source - www.mastergrad.com
Preparation of the kitchen project included work on drawing a diagram in a special program, calculating all the parameters, preparing the components of the headset, acquiring accessories and accessories. Photo printing on the facade was carried out by a specialized company. Then followed the assembly of furniture, and its installation in place. The process turned out to be much more complicated than it seemed at the beginning. But the result is fascinating.
The main problem of the room was the unusual geometry of the box, the walls are very difficult to measure. This is due to the fact that in the left corner there are gas pipes and a riser, which greatly interfere with the measurements. It was possible to transfer them, but this should be done only by specialists whose calling the hostess did not dare. The only thing, during the installation of the kitchen, I had to change the direction of the gas pipe, cut off one process.
In the photo you can clearly see how the room looked before the repair, and what it was transformed into after.
During the repair, unforeseen moments always arise that are difficult to foresee. In this case, it turned out that the table ordered in Odyssey with a table top 60 * 100 cm was unstable, it became clear when the hostess relied on him when moving. Additional reinforcement of the countertop was required.
To strengthen the countertop allowed driving two pins into the wall of the "crutches" of screws with a diameter of 6 mm. The joint with the wall was also strengthened. 6.5 mm diameter tubes were driven into the prepared holes. The junction was laid with a strip of chipboard.
Under the dining table, the built-in pull-out basket of three tiers was very well placed. A special building was created for her, which hides the contents, and absolutely does not interfere with the people sitting at the table. It is convenient to store groceries in baskets.
Hood done built-in, the corrugation is hidden under the casing. Since the inlet and outlet of the pipe is offset, the casing closes the center and the right side of the cabinet.
Corner wardrobe with a transition, it has a little more depth compared to neighboring cabinets. This is a justified solution, which allowed to successfully dock the facades of all wall cabinets. At the same time, the visual difference in depth is not striking. Photo printing looks more realistic on the surface of facades. The size of the picture is 58 * 66 cm.
An interesting solution is a stove built into the countertop. This option was born spontaneously, and many users of gas stoves consider this option dangerous. But the built-in design looks very organic.
The cabinet door with a dishwasher opens with the Aventos HF folding elevator, a very attractive device. The fear that it would not be possible to select the necessary amplifiers was not justified, even the elements of low power make the design reliable and convenient to use. An amplifier is selected depending on the size and weight of the facade, this part consists of an aluminum profile and plexiglass. The lift allows you to fix the facade at any level, and it closes very smoothly and without knocking on the cabinet.
The pencil case is divided into two parts, the project is quite interesting.
The lower part consists of two compartments, which include three drawers, they move along the mini-guides, from the bottom there is one compartment with a folding facade.
The upper part is a cabinet with built-in bottle-holderwhose width is 16 cm. The design occupies a compartment along the entire depth.
With great interest I always read your comments to my articles. If you have any questions, feel free to ask them, leave, you are welcome, Your feedback in the form below. Your opinion is very important to me. Thanks to your criticism and thanks, I can make this blog more useful and interesting.
I would be very grateful if you rate this post and share it with your friends. This is easy to do by clicking on the social media buttons above. Do not forget the article you like Add to bookmarks and subscribe to new blog posts on social networks.
