The remote control is a convenient thing that allows you to control all processes without leaving your place. But it does require batteries that need to be replaced periodically. It is very simple, but sometimes difficulties can arise.
How to insert batteries into the remote control
The content of the article
-
How to insert batteries into the remote control
- Plus and minus: how to figure it out
- Battery location depending on the type of remote control
- What difficulties may arise
To insert new power supplies into the remote control from the TV, you must do the following steps:
- We take the remote control device.
- We need a back panel, because that's where they are. Turn the remote control over.
- We are looking for a place where the batteries are located (it may be different, depending on the model). To facilitate the matter will help instructions. If it is not there, look for pointers (in the form of arrows). If there are no signs, try to find the seams. Another difference of the cover is the ribbed surface.
- Open the lid. To do this, pull it up or down, depending on the location of the arrow. Some types of caps are covered with a screw. Then we need a screwdriver.
- We remove old power supplies. They can be finger, little finger and flat (the latter are rare). In most cases, there should be two, but in some models (for example, Sony) one.
- Replace the batteries.
Plus and minus: how to figure it out
When replacing, the batteries must be correctly positioned. One side of the power supply has a plus, and the other a minus. The device itself also requires a pole on one side and a minus on the other. There are 2 ways to identify them:
- On the remote control it is often written which side is plus and which minus.
- A minus battery has a flat side. Plus, contact with a slight bulge.
Battery location depending on the type of remote control
Location may vary slightly depending on the device model. They can be in the lower, upper part or in the center.
Attention! Look for a ribbed surface. And remember, the cover is on the back, do not look for it where the buttons are.
What difficulties may arise
Difficulties can arise in three cases:
- I can’t determine where is the plus and where is the minus. It is very simple. Follow the instructions above.
- The device does not work with new batteries. Power sources may not work. Replace with others.
- Replacement did not help. Then the reason is in the remote.
The power in the remote control is not so difficult. You just need to adhere to certain rules.
