No one is immune from the various breakdowns of their furniture. Every time acquire a new device - an expensive option. Therefore, this article will look at how you can transform an old chair in a completely new, without using costly and difficult.
How to disassemble the computer chair - procedure
The content of the article
-
How to disassemble the computer chair - procedure
- How to disassemble the back
- What challenges did you face
There are a few so-called failure of the computer chairs sources. Accordingly, each of these individual techniques should be used to eliminate. The most common breakdown is considered to be a gas lift. For its elimination will require a substitution. To do this, it is necessary to arm the following tools:
- Screwdriver.
- Hammer.
- Lubrication.
- Pliers.
- Bolt.
After preparation can proceed to the main part. Following the instructions in the sequence, you can easily update the structure:
- The first thing is to remove the wheels. Then you can remove the back by unscrewing all the fixing. At this stage, do not forget the armrests - they too should be removed from the main body.
- Then pull off the seat should be at the expense of loosening the screws on the bottom. After these manipulations, you will be able to push the safety guard. This will help you to detect gas lift. It will have to beat with a hammer. It may happen that the process will be tight, this should be used for technical lubricant and continue the original action.
- As for the cross, because it is the execution of similar steps. However, the main difference is the use of pliers. The process itself is represented with a gently tapping parts.
ATTENTION! Take care that the gas chamber was untouched (it is located in the center of the structure). You can also apply a lubricant to facilitate the work.
- In the end it will be necessary to collect all the building back. That is screwing the seat to the original position, crosses the collection, pre-installation of wheels and gas lift upgrade through a corresponding recess. Then it is necessary to put the housing and fasten the seat completely.
How to disassemble the back
Most people often wonders who is to remove the back of the building. Most often it is necessary for the foundations of the constriction. You do not need to disassemble the structure completely. It will be enough to make out the necessary individual parts. The only thing that can be mentioned, since it is possible to mount the difference of each model. However, as evident from the principle of a more or less similar. Disconnect the back of the chair - a simple process. You just need to arm themselves on their own and remove detail on the back, after which the element can easily be tilted away from you. It is now possible to remove the case and replace it with fresh, pre-undock latch accurate movements.
What challenges did you face
Before the work is to be understood the difficulties you may encounter. This list includes the following points:
- During prolonged operation of parts can be connected with each other so that they will be difficult to separate. To prevent such a phenomenon, it is recommended to use a special lubricant and electrical appliances.
- Since the design has a smaller components, for them should be monitored closely. For this purpose, it is desirable to summon an assistant, who would perform such a function.
- Because of the complexity of some devices, can be difficult to parse. Therefore it is not an exception, it will need additional tools. Their use should not forget about safety. All actions should be carried out as accurately and neatly.