How to stick the film on the tablet correctly: instructions

The tablet as a product, according to state standards, must be delivered with a protective film glued to the screen. The role of this film is understandable: it protects the monitor from debris, dust, grease and mechanical damage. But over time, with active use, this film becomes unusable: it will inevitably be driven air bubbles, causing distortion of the perception of what is happening on the screen and preventing the passage of the signal. In addition, many developers place advertisements on film, which also interferes. In any case, sooner or later, the protective coating will have to be changed.

How to stick a protective film

Of course, there are users who refuse protection, and calmly slide their fingers on the bare screen. But then the monitor will quickly use up its resource.

If a person has never previously glued a new film to the screen of his tablet, and decided to do it on his own, he risks spoiling the new coating and the screen itself.

Reference! Without proper skills, it’s almost impossible to stick a barrier cloth - pieces of garbage, dirt, air bubbles will certainly get inside. Repeated bonding and subsequent peeling of the film from the display will significantly reduce its life.

First of all, you should pay attention to what you are buying. Cheap products will not force to lay out a large amount on the counter, but they also serve much less often. Of course, you don’t need to go to extremes and buy something super advanced for a million per square decimeter - the quality also has its limits. The optimal one will be to choose something average, not outstanding in anything. It is advisable to choose a film whose manufacturer matches the manufacturer of the tablet. If this is not the case, then universal, or “alien” is also suitable.

The purchased product is strictly recommended to be cut to the shape of the tablet window. The procedure itself is best done in the bathroom (in the presence of hot water). A hot stream will attract dust particles to itself, and this will protect the screen from unnecessary scratches. Make sure that the spray does not get on the gadget - all electronic devices are afraid of moisture.

If the tablet was used in the absence of a film, then before application, the display should be wiped to save it from oily stains and microscopic specks. How and what to wipe is described below in the corresponding section. The tablet should lie horizontally. Any solid, but not sharp flat object in the shape of a thin rectangle will serve as a tool - a bank card is perfect.

The film comes with a second layer that protects the adhesive side from drying out. This second layer needs to be peeled off, and as soon as possible so that nothing from the air does not have time to stick, but at the same time gently glue the corners to the screen on the top. Now with one hand (if you can do this together - then with two hands) you need to hold lower, non-glued corners, and gradually coats the display, smoothing it flat subject. Movements should be performed left-right, gradually shifting to the bottom. If you approach the process with enough patience and accuracy, then the film will fall well.

How to wipe the screen

Water or wetter wipes are not suitable for such procedures. Special compounds sold in equipment stores save from oily stains. Often, these forms have the appearance of a spray. The spray should be applied to the napkin, and it, in turn, wipes the screen. It is not necessary to press heavily on it - the composition finishes with harmful substances with simple contact.

Dust particles are removed using paper tape. It must be glued, and then immediately torn off. The sticky surface will take all the trash with you.

If the glass of the tablet turned out to be so damaged that cracks formed on it, then it makes no sense to try to glue fragments - monitors of all modern devices, not even equipped with sensors, contain a liquid that spills out when breakdowns. The display can be replaced at a service center.