Why the dishwasher does not dry the dishes - the reasons for the refusal to dry the dishes in the dishwasher

After washing the dishes, the machine proceeds to dry it. Depends on the quality of drying, what kind of dishes will be after the end of the cycle - dry, beautiful, shiny, or wet, with drops and stains, which you can not put on the table. You have to pick up a towel and do the work yourself.

If drying occurs according to the second scenario - this may be a signal about the malfunction of the dishwasher. Types of malfunctions associated with poor-quality drying will be considered in the framework of this article.

Types of dryers in the dishwasher (condensation dryer, turbo dryer)

Condensation, or natural drying occurs when the dishes gradually cool after rinsing with hot water. The steam from the dishes condenses on the walls of the chamber, after which the drops flow into the container. The plus is the efficiency of the method, minus - a very long drying time, some housewives, for example, start the machine in the evening, so that by morning the dishes will dry properly. The option to get rid of condensation on the dishes is to open the door of the dishwasher.

Turbo dryer, or as it is also called, convection, is carried out by supplying hot air with the help of a fan. The advantage of the method is speed, however, for its implementation, a heating element that consumes a significant amount of electricity should work. Some owners embark on a trick - turn off the machine after the last rinse cycle, and open the door.

Convection-Drying Dishwasher Troubleshooting

How to check the operation of the heater and fix the breakdown

Tena are not subject to independent repair, replacement is necessary. Its serviceability is checked with a multimeter, a ten is located in the lower part of the dishwasher. To remove it, remove the bottom of the machine. After that, the operation of the heating element is checked and, if necessary, its replacement, best of all the same.

How to check the functionality of the temperature sensor and troubleshoot

The temperature sensor is located in the opening of the chamber for collecting water. In working condition, he controls the temperature of the water and gives a command to dry the dishes on the heater. In case of its malfunction, the drying process does not start due to the lack of a command for the heating element. To replace the sensor, wires are removed from it, then it is taken out, after which a new device is connected. At the end of the test conduct PMM performance.

How to troubleshoot if a fan or relay is broken

The relay is usually located on the control board located inside the door. To remove it, unscrew the bolts and remove the cover on the inside of the door. If you have a skill in handling a soldering iron, you can solder the relay yourself. In case of doubt in success, do not hesitate - call a specialist, he will do everything. The fan will have to be replaced, since it cannot be repaired. A sign of a fan breakdown is the lack of sound during operation of the turbo dryer.

The location of the fan is different for different models - on the side wall, in the lower or upper part of the camera. Getting to the fan is not easy, you have to disassemble almost the entire machine.

Condensation Dishwasher Troubleshooting

The main failures in this type of PMM are:

• failure of the heater - the water does not heat up, the dishes, respectively, do not wash and do not dry. Replacing the heater is done in the same way as with dishwashers with a turbo dryer;
• malfunction of the temperature sensor - replace as described above;
• breakdown of the relay on the control board. We also considered this malfunction, everything is done in the same way as in PMM with a turbo dryer.