How long should disconnected refrigerator?

Time of non-stop operation of the new unit depends on many factors. Among them, the temperature in the room where the device is taken, the compressor capacity, the volume of chambers, number of products have been added to them, the refrigerant type, etc. Mean values ​​for the empty unit with exposed on at least the temperature regime is approximately 1-2 hours. But it is arbitrary, since you can find a record in the instructions that even a 24-hour continuous operation of the new device is not considered a defect.

How many should turn off the device, which has long been in the works?

The refrigerator of any embedded thermostat and sensor to allow display mode and desired temperature and shut down the compressor upon reaching the relevant indicators respectively. If the long-used appliances placed products, they have cooled down, the compressor can be switched on less often.

Observant users and experienced refrigeration note that the average time of operation of the device and during his rest approximately equal to each other. There even is such a thing as an average cyclic coefficient, which is equal to 0.5.

What influences the duration of the (cooling) refrigerator

What should be the surface for mounting the instrument

Improper installation of refrigeration equipment threatens to quickly fail. Therefore, it is important to pay attention to the flatness of the surface on which it is placed. Leveling feet can help to put the unit on a level, if there are slight unevenness in the floor. Moreover, the device must be at a distance from the radiators and gas cookers.

The importance of compliance with the first connection in the electric refrigerator

The first time you connect you must observe a number of rules that will extend the life of the device:

• After delivery of the unit switch in the network must be done no earlier than after 3-4 hours. The specified time will allow him to adapt to the temperature conditions of the premises, which is especially important, if you purchased a refrigerator in the cold season.
• Use a surge protector in the event of failure to ground the socket. If the power supply has a constant voltage drops, it makes sense to connect through the stabilizer.
• The first cycle be carried out without placing products.

Why is it important not to overload the refrigerator products?

The lack of uniform distribution of the products in cells can disturb the circulation of cold air. For this reason, the products can not receive proper cooling and will begin to deteriorate. Excessive workload will lead to an increase in temperature on the lower shelves.

Cyclicity of work included various models of refrigerators

Cyclicity functioning of popular models (Atlas, Indesit, Samsung, LG) with dropping defrosting system enables the thermostat. From the set temperature and other factors, it depends on the duration of non-stop operation of the compressor. In general, the Atlanteans full cycle lasts longer. The normal cycling rate from 0.37 to 0.5.

As for devices of the same manufacturer with No Frost system, then after cooling and freezing process is driven by the defrost. Last performed through electric heater evaporator. The average duty cycle lasts for 9 to 16 minutes. Moreover, cooling takes place over 2-5 minutes, the rest time goes on thawing.

What if the refrigerator for a long time will not turn off?

The most common causes of long non-stop operation as follows:

• loose fit of the door to the housing;
• established by rapid cooling mode;
• high ambient temperature.

These reasons do not indicate a defect and the normal cyclical nature of the work can be restored independently. Otherwise it is better to call the master. It is possible that the door seal is worn out, broken temperature sensor, the control unit is defective, there is a blockage of the capillary tube or a leak freon compressor resource is exhausted.