It will not open the tap in the mixer: Why will not open the tap, what to do

Mixer creates comfort and convenience in the bathroom and in the kitchen. However, there are situations when it crashes. It is therefore important to know how you can solve a variety of problems, because they do not always advantageous to cause the master or plumbing.

One of the most common problems - it will not turn the tap handle. What to do in such a situation? Let's take a closer look at these questions and try to answer them.

Why will not open the mixer tap

There are many reasons why the crane may be difficult to open. One of the most common - it's dirty water. Various elements of it may get stuck between parts of the mixer, which ultimately acts as a brake or stop for them.

Also, tight turn can arise due to mechanical damage of individual components of the mixer. In addition, the elements can simply morally obsolete, t. E. their life came to an end, and they can no longer function normally.

In each of the cases do not need to run to the store and buy a new bathroom fixtures. Any of these problems can be eliminated.

Attention! To the mixer does not bother you as much as possible, buy well-known brands. It is advisable to proper care of equipment. From it will also depend on the efficiency and service life of the mixer.

What if the mixer tap tight turns

First of all, remove the faucet and take it apart to remove the cause of failure. After that, clean all parts - in the first cartridge. Further, the mixer is necessary to collect and check it on working capacity.

Please note the important caveat - all these manipulations should prodelyvat only if you are good at plumbing and possess skills such work. Otherwise, any attempt at repair could result in another breakdown, and worst of all, the complete failure of the sanitary appliance.

If the problem has arisen because of the dirty water, it will help improve the situation a thorough washing and cleaning of all components of the device. After cleansing all the mechanisms begin to work correctly. To wash the best fit two basic ways:

1. With the use of detergent. Mix the hot water and a mild detergent in small bowl. All the elements put into it and rinse. If you have found long-standing pollution, they can wipe the paste with the help of a toothbrush. Thereafter, flush all elements under warm running water.
2. By chemical means. Put on gloves and take special chemicals to remove lime deposits. It will cope with any pollution. If not, then it helps ordinary vinegar, but it can not be used on iron details. Moisten cloth and light motions apply it to the mixer elements. After that, leave for 30 minutes all the details, but after all this time rinse thoroughly under running water.

In the second case, the main thing - do not use a large amount of chemical agent or vinegar, as they can damage the components and crane components.

If the problem is related to the performance of the mixer mechanical problems, then in that case it is important to understand what kind of item needs to be repaired. It will also have to disassemble the valve, and a detailed study of all units and components, then replace the faulty new one.

In operation, the mixer can dry lubricant that helps make the crane turns smoother. If for this reason it has become tight rotate, it is possible to solve the problem in just a few minutes, re-lubricate all the necessary elements.

Use only high-quality grease. Products of unknown origin can only hurt the elements or dry quickly clog all the holes, and thus result in completely unusable plumbing fixtures.