Diverge joints wallpaper 5 causes of the problem and the best way to fix it

Getting repairs, homeowners in mind always represent the final result. At this point, they overpowered pleasant anticipation and dreams of a perfect housing interior. But often it happens that in their dreams ripped unforeseen problems.

It seems that the most difficult thing behind, cut the wallpaper, glue involved and walls plastered. But there it was, as soon as the paper web begins to dry, the outside appear serious complications, namely dispersed unsightly joints.

Deal with this problem and you can, of course, necessary. But first you need to find out the main reasons for the discrepancy joints. Below we will tell about the 5 most common of them.

The reason №1 - Lack of glue

The first thing you should pay attention when dispersed edges of wallpaper paintings - is the amount of glue applied to the edges. If it is not enough, the grip of the walls will be minimal. Remember that a layer of plaster is much thicker and porous wallpaper, glue and so it absorbs the maximum. Therefore, before you finally flatten the paper sheet on the wall, walk a brush with glue on the edge of the wallpaper again.

Reason №2 - Excess glue

Along with the lack of an adhesive, the reason that dispersed joints may be in excess glue. Excessive amounts of adhesive promotes swelling wallpaper. When the paper is soak, it has stretch property. As such, you and kleite them on the wall. But when the adhesive starts to dry, the wallpaper back to its original state, and by narrowing the gaps of the material appearing on the walls.

Reason №3 - Defective wallpaper

Another factor responsible for the difference at the junction of wallpaper - a marriage in the material. It often happens that manufacturers produce defective goods, the edges of which roughly cut obliquely. To avoid this, experts recommend to carefully choose the products in the store and carefully review each roll of wallpaper.

Reason №4 - Poor preparation of walls

Before embarking on wallpapering, you need to make as a rough finish walls. If you plan to hang wallpaper on non-prepared ground, namely on non-primed and leveled wall surface, with the probability of 99% of the joints on the wallpaper disperse the day after glueing Wallpaper.

Reason №5 - «wrong» Glue

Often the savings on materials leading to serious consequences after repairs, and saving on glue vivid example. Producers of finishing materials do not get tired to say that the adhesive must meet the wallpaper type. Usually on the packaging with adhesive composition indicate information about what type of wallpaper that they are compatible. But the high price for a certain kind of glue makes the buyers to save it, and then bitterly regret.

We solve the problem correctly

If it really happened, that the joints are only pasted wallpaper dispersed, then we suggest you to correct this misunderstanding. Fortunately, there are many ways, and you can choose the best for yourself.

• Perekleit wallpaper again. Yes, this radical method, which requires additional nerve and financial expenses. But if the gap between the thicker the wallpaper three fingers, it is the most obvious and high-quality solution;
• Paint over the marker. No, the children pencils and markers in this case does not help. You will have to go to the hardware store and buy a special pen;
• Disguise the joint. Most often, homeowners have resorted to this method. To cut a strip of wallpaper slightly more than the width of the space differences, and glue it under the edge of the wallpaper that hang on the wall;
• Install the panel. Dispersed on top of wallpaper can be pasted panel or a baguette. So in one fell swoop, you not only hide the defect, but also add to the interior of originality.
• And remember that mistake during the repair can happen to anyone. You should not become discouraged and worry about it, because the solution to the problem always lies on the surface, the main thing to know where to find him.