Acrylic paints have a fairly wide scope. This is due to their beneficial properties. Such paints can be used on almost any surface, they are absolutely environmentally friendly, dry quickly enough, enough resistant to external influences and to fading, give a long-lasting effect and even after drying can remain flexible and durable.
At first glance, there should not be any difficulties when working with them, but many are faced with uneven staining. In this case, uneven stained stripes or spots may be observed on the surface. There may be several reasons for this:
- Firstly, you need to consider that this paint really dries very quickly. Therefore, if you need to create color transitions, you need skill to perform this quickly, then the picture will turn out to be uniform;
- Secondly, it is impossible to achieve an even coating if the paint has thickened after a long storage. It is impossible to reanimate dried acrylic paints in any way. Therefore, it is important to be able to extend their lifespan. To do this, check the condition of the paint every few months, stir, add, if necessary a little cold water or a special solvent and close tightly until the next check either use;
- Thirdly, uneven coating may be due to the absorption of the paint. It penetrates well into porous and loose surfaces. Therefore, it is better to apply a primer before painting, after which the acrylic paint will neither spread nor absorb anyhow.
When the fabric dyes with acrylic paints, you need to follow a few simple rules:
- Clean and degrease the surface;
- In no case do not stretch the material, as in the end it can deform the resulting pattern;
- If a two-layer finished thing is painted, you need to put some plastic substrate under the front side so that the primer and the paint itself do not print on the other side of the product;
- When painting on colored fabric is done, it is best to complete the intended drawing first in white, and then duplicate it in other colors;
- In order for the drawing to turn out uniform, it is necessary to wait for the base to completely dry, otherwise the paint will mix with it and the base effect will disappear.
During repairs, the ceiling is often painted with acrylic paint, and it is quite difficult to achieve an even coating. This usually happens if the drying time is not maintained. Of course, it depends on the microclimate in the room and other factors, but in general, you can check the drying in a fairly simple way. It is necessary to take a small piece of polyethylene, glue it around the perimeter with tape, stick it to the ceiling and leave it for about 3 hours. If after this time no condensation forms on the film, then the ceiling is dry. If not, you need to wait another time. Usually enough to dry the first layer is night.
-
How to remove platbands without leaving marks on the door
-
Which stepladder is better: aluminum or steel
-
How to make "fur coat" plaster without a special tool
-
What will happen if you paint ordinary wallpaper instead of special
-
How to glue a fiberboard sheet to an uneven wall
-
The nuances of the overhaul of the apartment in Khrushchev
-
What polycarbonate is not suitable for a balcony fence
-
How to save on the construction of a half-timbered house
-
What type of ceiling is not suitable for a balcony
-
How to equip wall drainage for a private house
-
What is the difficulty of cutting corrugated with relief
-
What you need to know when designing a half-timbered house
New publications are published daily on our channel in Yandex. Zen
Go to Yandex. Zen
