How to check the quality of the work of a tiler to a layman

At the moment, one of the most common finishing materials for a bathroom or toilet is tile. But in order to correctly perform the installation, you need to have certain knowledge and be able to handle the tool. Many in this case prefer to entrust the work to a specialist. It is best to work through a proven construction company that provides services in this direction for several days. In this case, you can be sure that the work will be performed by a truly qualified master who knows his job perfectly. But in any case, at the end of the work, you need to check whether everything meets the requirements and is performed qualitatively.

Angles

It is recommended to start from the corner of the room, all horizontal seams must necessarily converge in one plane. The tile is always laid around the perimeter, and if there are even slight deviations, then this indicates that the tile does not lie in one plane.

1. Laying tiles in the bathroom always starts from the front corner, which is often located near the bathroom.
instagram viewer
2. In these places not even a minimal discrepancy falls.
3. It is also worth paying attention to the angles that are opposite the bathtub, although this is a closed corner and does not strike the eye, there should not be any inconsistencies.

It is also worth paying attention to the size of the seam between the tiles, a qualified craftsman uses special plastic crosses in their work, which guarantee uniform seams. Of course, even the most experienced specialist will not perform everything as qualitatively as possible, and here an error of 1-2 millimeters is allowed, this will not be evident and stand out.

Flatness

The tile is laid strictly according to the level, both horizontally and vertically, it will not be superfluous to check the diagonal. After laying, there should not be any irregularities and waves, to make sure of this, it is worth using a long level or a plaster rule. An even long bar is suitable for these purposes. If there are no cracks and holes, then the work is done efficiently.

Voids under the tiles

If we talk about the wall, then voids are allowed here, but everything should be in a reasonable and adequate limits, as otherwise it will be possible to damage the tile, any negligence will entail a chip. With a minimum number of voids, this will not affect durability, as well as appearance. In general, the master must withstand the drying period and align everything during preparation. To make sure that there are no voids, the owner can simply tap the surface.