How to make "fur coat" plaster without a special tool

To create a stucco mortar, you will need tools:

• Bucket for a batch;
• Plain water;
• Sand (pre-sift);
• Cement;
• Wooden or plastic stick;
• Broom or broom.

Making and applying plaster may seem difficult, but it is not. A wooden stick can also be used to bring down excess plaster from a broom. It is necessary to pay attention to the correct arrangement of materials in order to prevent the plaster from splashing.

When using a broom, it is better to take small areas. To apply a fur coat, you can take a roller. First, the plaster is applied to the wall, and then, thanks to the roller, the necessary relief is obtained. For the desired decoration effect you need to have knowledge and skills.

With a compressor, plastering will be easier. First you need to choose a gun to the compressor and do the filling with plaster. Plaster consumption can be reduced by using a spray gun. The mechanized method involves uniform and thin application of the stucco mixture. In a specialized store, consultants will help you make the right choice of nozzle for the required fraction of a fur coat.

How to prepare the surface and apply plaster

Before plastering, you need to do preliminary preparation of the wall. The walls in the new house must be primed. For walls in old houses you need:

1. Fill all cracks and indentations with cement. Get rid of grease stains, dirt and dust.
2. Tap all the walls with a spatula. If there is no peeling of the old coating, then begin the primer treatment. This is possible with exterior finishing work.
3. To cover the plaster under the fur coat, get rid of the old finish.
4. The primer is applied in multi-layer. It is necessary to wait for it to dry. You can proceed to the application of plaster.

There are several methods of plastering walls with a fur coat. A popular way is:

• Plastering is done by abrupt spreading of the mortar on the base. Next, with a trowel or wooden spatula, it is leveled.
• Thicker plaster is needed for the top coat.

Golden rules of work:

1.  Repair work should occur at t + 5-27 degrees.
2. If direct sunlight hits the finish, the surface will quickly dry out and cracking and shedding will occur. In summer you have to spray the base.
3. To get an aesthetic decor, a fur coat should be applied in 3 layers, no less. Layers are applied after drying.
4. Forget about saving on the primer.
5. To color the decor, it is better to use natural colors, for example, iron ore, asbestos, hot coal and manganese.