Why do holes form in polycarbonate?

It often happens that polycarbonate is damaged and requires repair. The reasons for this may be small holes or cracks after large precipitation in the form of hail. A heavy snowfall leads to a subsidence of the polymer. This is due to the incorrect selection of the thickness of the polycarbonate sheet or the poor quality of the material itself.

For rare repair of polycarbonate, it should be bought only from reliable manufacturers and forget about saving on its thickness.

For a long service, installation should be carried out according to the rules, and stored in a well-ventilated area.

Incorrect installation can lead to more dire consequences. According to all rules, polycarbonate sheets must be packed in a special film for transportation on both sides. The first side is transparent, and the second color. The side of the sheet, which is covered with a colored film, has a layer of UV protection on the surface. If installed incorrectly, the polycarbonate sheet will not “live” until the end of its shelf life. In a short period of time will begin to collapse. As a result, holes will appear, and its further scattering will occur.

Reasons for the appearance of holes:

• Saving on sheet thickness should be forgotten. In winter, it is necessary to get rid of snowdrifts from the building. The weak power of the frame is not able to withstand unexpected loads in the form of bad weather conditions;
• Before choosing the right polycarbonate sheet, it is important to check it for quality. Most manufacturers often save on it. You can often find a weak, poor-quality section of the profile sheet.

To prevent the appearance of holes and various kinds of damage, you need to think about acquiring a high-quality design with elements that are distinguished by their strength and reliability.

For the reliability of the polycarbonate structure, you should adhere to these tips:

1. Correctly install the base and the polymer itself.
2. To build a greenhouse, choose sheets of greater thickness.
3. To clean the snow from the roof. Engage in the installation of supports from beams and logs in winter.
4. To make a more durable frame, use profile fittings and profiles.
5. To secure the polymer to the structure, use thermal washers. They do not need to be attracted closely, but leave about 1 or 2 millimeters, since polycarbonate tends to expand when heated. Then it increases in size and may be damaged.