Unfortunately, you can’t do practically anything with constantly increasing utility tariffs, but still everyone has the opportunity to pay their bills cheaper. In order to reduce water consumption, it is not necessary to take a shower or bath every few days, it is enough to use water-saving nozzles. Moreover, the savings are more than tangible - up to 70%.
Such devices began to appear on the market for a long time, but at that time they were of very low quality, because there was practically no advantage from nobody could feel their use; moreover, many complained that they paid more for the nozzle than they saved on communal apartment. Now the situation has changed dramatically, it’s enough to correctly approach the issue of choice and you will get a really high-quality nozzle.
Aerator nozzles
When it comes to water-saving nozzles, aerators are primarily meant. When water from a faucet passes through the nozzle, it is saturated with air and breaks up into a large number of small jets, resulting in a soft and solid stream. In this case, half the water is consumed, but in reality the person does not notice this, because the flow is still optimal for washing dishes or taking hygiene procedures. But it will be very noticeable decrease in meter reading and utility bill.
The nozzle is made in the form of a cap; it is screwed to the mixer. Inside the nozzle there are several nets at once, and for kitchen faucets often it also has a cartridge for water purification. The durability of such a device largely depends on the material used to manufacture the case; the best are brass, bronze and ceramic products, but they are more expensive in cost. Plastic will cost cheaper, but it has a low service life. Everyone can install the nozzle on the crane independently, it does not take more than a minute.
Head regulation
When it comes to water consumption, the use of nozzles will be very justified. But when it is necessary to draw a large amount of water, for example, into a bath, it will take almost twice as much time, because air will come out with water. To prevent this from happening and you do not have to constantly remove the nozzle, and then put it back in, just choose a model with a regulator. A regulator is a screw that can be adjusted using a regular knife.
-
For what devices people did not conduct wiring, and then very much regretted
-
Where you should not put a washing machine in the bathroom
-
Why was ash added to the mortar in masonry before
-
Smart sockets: why call a coffee maker or kettle
-
Frequent and dangerous mistakes for working with a grinder for beginners
-
What types of screws are best not to use
-
What can happen if you do not have grounding in the apartment
-
New bill: how much do you have to pay for electricity
-
The weaknesses of cheap food: how to extend the life
-
Is it possible to restore a damaged foundation
-
Is it profitable to turn off the power supply and switch to your
-
What you will face if you combine a balcony with a room
New publications are published daily on our channel in Yandex. Zen
Go to Yandex. Zen
