Replacing the pump of the Indesit washing machine is necessary in cases where the water does not drain at all or leaves for quite a long time, and the unit itself is too noisy. The replacement process is quite simple and does not require special equipment or skills. Step-by-step instructions with photos are presented in this article.
The content of the article
- How to diagnose a breakdown
- Tools and materials
- Step-by-step instruction
How to diagnose a breakdown
First you need to make sure that it is the replacement of the pump in the Indesit washing machine that is required. Usually the device itself conducts diagnostics and issues an error F05. If there is no display, then a combination of indicators will light up:
- super wash;
- extra rinse mode;
- soaking clothes;
- spin mode.
If these signals are not present, you can see how the machine washes. There are several signs that allow you to make sure that it is the drain pump that has failed:
- the water drains, but noticeably longer than usual;
- the unit finished washing, while the water remained in the tank;
- the machine drains water, and the program has not yet been completed;
- the water drains normally, but the unit gives a strong rumble.
The reasons are often associated with the pump, so you need to figure out how to remove the drain pump of the Indesit washing machine. Although such phenomena can also be observed in the event of a clogged siphon, sewer pipe and siphon. If in doubt, these elements should also be checked.
Tools and materials
Replacing the drain pump in the Indesit washing machine begins with the preparation of the necessary tools and materials. For this you need to take:
- screwdriver
- a knife or other tool with a dull blade;
- penknife;
- pliers;
- multimeter.
You will also need a drain pump. It is better to purchase a spare part last, after it is clear that the pump has broken.
Step-by-step instruction
It is not difficult to understand how to change the pump in the Indesit washing machine. Step by step repair instructions are as follows:
- Lay the machine on its left side (when viewed from the front).
- Finding a drain pump is not difficult - it is in the corner, it looks like this.
- Remove the front bottom panel - you can do it by hand without additional tools.
- Unscrew the bolts that secure the pump from the outside.
- The next step, how to replace the pump in the Indesit washing machine, is due to the fact that the element must be turned clockwise and removed.
- At this stage, it is better to take a photo so that you can correctly install the new pump later. Next, remove the red plug through which the wire is connected.
- Loosen the nut and remove the old pump. At this point, some water will flow out, so you need to prepare a rag.
- Install the new pump, aligning the bolt holes correctly.
- Assemble all parts in reverse order.
- Install the front bottom panel, return the machine to its original position and test in any wash mode.
Now it’s clear how to disassemble the pump of the Indesit washing machine. To do this, first carry out diagnostics, then lay the unit on its left side and remove the old part. As you can see from the step-by-step instructions, removing the washing machine pump is a fairly simple procedure that can be completed in a few minutes. But if the error is related to another node, and there is no exact understanding of the cause, it is better to call a specialist.
