How to clean the washing machine with your own hands? How to clean the washing machine from dirt? – Setafi

Cleaning the washing machine is done by hand, it is not necessary to call a specialist for this. Moreover, the parts themselves can also not be removed, with the exception of the drain pump filter. To work, you will need improvised means - baking soda, vinegar, a screwdriver, a rag and others. How to proceed is described in this material.

How to clean the heater and drum

If you wonder how to clean the washing machine from dirt, it is better to start with the drum and heating element. And the principle is the same. Since these parts are constantly in contact with water, calcium and magnesium salts settle on them, which form scale.

You can destroy this plaque with the help of acids, which are quite affordable. You can use improvised means - citric acid and food vinegar. One of the most common ways to clean a washing machine from dirt is to prepare a solution of baking soda and vinegar. To do this, take the following ingredients:

• alcohol or table vinegar concentration 9% 2 cups;
• baking soda 1/4 cup;
• the same amount of water.

You need to act like this:

1. Dissolve soda in water and pour this liquid into the tray that is designed for the powder.
2. Pour the vinegar directly into the drum.
3. Run the washer at idle at maximum temperature and for a long period of time.

There is another way to clean the washing machine from dirt. For processing, you will need several packs of citric acid, 10-20 g each. The specific amount depends on the degree of contamination. If the heating element and the drum have not been washed for a long time, it is better to take 5-6 packs. They act in the same way - they pour the agent into the powder tray and start it at the maximum temperature and maximum operating time.

How to clean the cuff

A cuff is a sealing gum, which is located directly in front of the door. To figure out how to clean the washer, you should bend the gum and carefully inspect it. Remains of villi, dust particles and other dirt constantly accumulate here. In rare cases, mold can even grow.

During operation, they act like this:

1. Bend the cuff, completely turning inside out.
2. Remove dirt with a damp cloth.
3. Then apply the powder of baking soda or a special tool - "Pemolux".
4. Leave for a few minutes, then rub over the surface and rinse with water.

Sometimes it is necessary to clean the washing machine from dirt and odor. Then, along with soda powder, you should use a special tool, for example, Domestos. It is used at the last stage of processing.

Tray cleaning

The tray is also periodically clogged with powder. This is not dirt as such, but simply an accumulation of detergent, which is also better to remove. In addition, rust and plaque can form around the container. For cleaning, the tray is pulled out until it stops. If it is equipped with a blue plastic insert, as in the photo, you must press it and pull it towards you with force.

If there is no such element, as, for example, with Indesit models, you can simply pull out the entire tray and press it down a little, push it from side to side and pull it out completely. Further, such a picture may open.

It is necessary to understand how to wash the washing machine inside from dirt. In the case of a tray, this is especially difficult, since individual places are difficult to access. In general, the work is laborious, but it can be made easier by spraying all surfaces with detergent. After that, leave for several hours and wash off, wipe dry, put the tray back.

Filter cleaning

Each model has a filter that protects the drain pump from clogging. Therefore, it is important to understand how to clean the washing machine so that water flows freely through all elements. For work, you need to take improvised tools and materials:

• a baking sheet with high sides;
• rag;
• regular flat screwdriver.

The cleaning instructions are as follows:

1. Open the filter by removing the panel at the bottom of the housing (pictured bottom right).
2. Spread a towel on the floor and place a baking sheet or a flat bowl.
3. Unscrew the lid, let the water drain (sometimes it can appear up to half a liter) and get all the dirt, and possibly foreign objects.
4. Next, it is clear how to clean the washing machine from dirt inside. It is necessary to wipe all surfaces and put the filter in place.

How to clean the inlet hose filter

If you carry out general cleaning, you need to inspect the hose filter that supplies water for washing. It is advisable to do this work 2 times a year. You will need to take an old toothbrush, pliers or pliers.

The instruction is this:

1. Close the cold water tap.
2. Rearrange the car with the back towards you.
3. Unscrew the hose nut and carefully remove the small filter with a mesh. To do this, use, for example, pliers.
4. Remove dirt from it with a toothbrush.
5. Install the filter and tighten the nut again.
6. Return the car to its place and turn on the tap.

Thus, all cleaning procedures, even the most complex ones, are carried out at home. Moreover, if the washing is quite intensive, it is worth doing them at least 1 time per year. If, on the background of pollution, a breakdown occurs, it is recommended to contact a specialist for an accurate diagnosis.