Ballu air humidifier: instructions for use – Setafi

Appointment of a humidifier. How the Ballu-Uhb 200 works.

The Ballu-Uhb 200 humidifier is designed to maintain a comfortable/user-defined humidity level in a room. A comfortable level of air humidity is considered to be relative humidity in the range of 40-60%. A mechanical control device, that is, what humidity parameter the user has set, this will be supported. There is no automatic mode.

The principle of operation of the Ballu-Uhb 200 is based on "ultrasonic evaporation": there is a small outlet from the water tank to the steam chamber. There, a small portion of water is affected by ultrasound, splitting the water into tiny droplets. Collecting, these droplets form a vapor cloud in the chamber. There, a low-power fan supplies air from the room. Thus, water turns into steam, through which air is passed. Humidity adjustment increases/decreases the amount of water that turns into steam.

Ultrasound that splits water is not heard by either people or pets. It and its emitting membranes are safe for all living organisms.

Why you need humidifiers

Naturally, to increase the level of humidity in the room. But why is this? Dry air adversely affects the life of people, animals, plants:

• Mucous membranes dry up from it - lips dry and crack, there is a burning sensation in the eyes
• It promotes the spread of infections, bacteria, viruses and diseases by airborne droplets.
• Causes fatigue, drowsiness, and reduced concentration
• In such air, plants often dry out / die.

In addition, in dry air, an increased electrostatic charge, more dust is formed in it - as a result, this spoils furniture and negatively affects musical instruments.

Specifications Ballu-Uhb 200. Device kit

Specifications:

• Power supply: voltage - 220 Volts, frequency - 50 Hertz
• Power: 28 Watts
• Current: 0.25 Amp
• Noise during operation: 35 decibels (or less depending on the mode)
• Water tank, volume: 3.6 liters
• Serves a room area: 40 sq. meters
• Dimensions: 16 x 34.8 x 16 cm (W/H/D)
• Weight without packaging: 0.95 kilograms
• Weight with packaging: 1.25 kilograms
• Backlight: built-in
• Timer: no
• Management: mechanical (manual)
• Maximum productivity: 350 grams/hour
• Additionally: built-in water level indicator, performance regulator, ultraviolet lamp, aromatizes the air

The kit comes with:

1. Sam Ballu-Uhb 200
2. Water filter cartridge
3. Documentation (manual, passport, warranty card)

How to use a Ballu Humidifier. How to connect the device correctly. How to fill the water tank.

To fill the water tank, you must:

Remove the tank from the atomizer itself, and then remove it from the base of the device. To do this, grasp the walls of the unit and pull up. After that, you need to unscrew the lid of the water tank. It unscrews counterclockwise. Next, fill the water tank and put it back in.

Humidifier usage/connection:

Plug the humidifier into an outlet. In this case, the voltage should be 220 Volts, and the frequency should be 50 Hertz.

If the device has a faulty plug or cable, do not try to plug it into the socket - it is better to contact the service center. Turn on the humidifier only in the correct position - if you connect it upside down, it may break.

Inclusion

Turn the control knob to turn on the device. A green light will light up around it, and after a few seconds, steam will start to come out of the humidifier. You can adjust the steam output speed by turning the same knob (to the right - more steam, to the left - less).

You can pour water from the tap into the water tank. All water from the tank passes through a special filter in the form of a cartridge. It softens water, retaining salts and other large elements.

Shutdown

To turn off the appliance, turn the steam speed control knob to the left until it clicks. After that, the lighting around the handle will turn off, the steam will stop coming out of the humidifier and the device will turn off. At the end, unplug the appliance. If you turn off the appliance by removing the plug from the socket, it can quickly become unusable. Such damage is not covered by the warranty.

When the appliance runs out of water, the indicator around the control knob turns red. This is to inform the user that the humidifier has run out of water. The device itself turns off. When you add water, it will work normally again.

Caring for the Ballu-Uhb 200 Humidifier

Any equipment needs to be cleaned in order for it to perform its functions properly. Ballu-Uhb 200 is no exception. To clean it, you need:

• Unplug the device from the outlet (otherwise, you risk getting an electric shock).
• Wipe the body of the device from dust with a soft moistened cloth (do not use other liquids to clean the humidifier - they may damage the body of the device / cause a fire).
• Wipe off residual water inside the water outlet under the tank.
• Wipe the membrane with a dry soft brush or cloth.
• Remove the water tank and rinse it. When washing, do not make much effort so as not to break it.
• Remove any remaining water from the sprayer and wipe it with a dry cloth.
• Dry the elements of the humidifier after washing. Check that there is no water left in the humidifier
• Reassemble the device.

The manufacturer recommends such cleaning once or twice a week, then the device will serve you for the declared 5 years. The warranty is issued by the seller and differs depending on the store.

How to store Ballu-Uhb 200

The model must be kept completely dry. If you do not plan to use the humidifier in the near future or you are moving, then before packing the device, it must be cleaned of dirt and moisture. Store the instrument in the plastic bag in the box or packaging provided with the instrument. The relative humidity of the room where the humidifier is stored should not exceed 85%.