Why does the washing machine fill itself with water? How does a switched off washing machine draw water? – Setafi

If the water in the washing machine draws on its own, this indicates a malfunction of the inlet valve or a clogged siphon. The liquid can come from the water supply and the sewer pipe, both situations require a solution. How to make repairs yourself is described in this article.

Main reasons

There are 2 main reasons why the washing machine draws water on its own:

• intake from the water supply;
• flow from the sewer.

If the liquid comes directly from the water supply, it will accumulate slowly. In addition, the water will be clean, which indicates a breakdown of the intake valve. Due to the violation, it leaks water and being "closed". To verify this, it is enough to close the shut-off valve. If in this case the water stops accumulating, then the cause is really related to the inlet valve.

It often happens that water comes from a sewer pipe, it will be cloudy and give characteristic unpleasant odors. The reason is related to the installation features, when the drain is connected to a siphon located under the sink. Sometimes it begins to clog, which causes the water level to rise. It flows into the drain hose, from where it goes to the tank of the machine.

Also, cases when the switched off washing machine draws water may be due to the absence of the siphon valve itself. You need to make sure that it is available and, if necessary, buy a spare part and install it yourself.

How to fix a breakdown

The repair method depends on the cause:

1. If the liquid comes from the sewer pipe, you need to clean it. Also, the violation may be due to improper removal of the drain. It can also be eliminated independently, although this is a more difficult task. If you are not sure, it is better to call a specialist.
2. It also happens that the cause is a non-working intake valve. It cannot be repaired, so you need to purchase a new part and install it in place of the old one. You can do it yourself only if you have the appropriate skills.

Do-it-yourself replacement is possible according to the following instructions:

1. If the machine is a common front (horizontal) loading, the valve is located under the top cover. If the loading is vertical - then under the side.
2. To find it, turn the unit upside down and remove the cover.
3. Then disconnect the water supply hose - otherwise it will interfere with the installation.
4. The hoses are disconnected from the valve, each clamp is opened and the wires are removed, paying attention to their polarity (you need to remember).
5. Since the electromagnetic type valve cannot be repaired, it is removed and a new part is installed by connecting it to the hoses.
6. It is also better to put new clamps so that the fastening is as reliable as possible.
7. Then connect the wires, taking into account their polarity.
8. Fix the valve, connect the hose and check how the machine works.
9. If everything is in order, there is no leakage at the joints, you can put the cover back on and put the unit in place.

Prevention measures

Even a properly working machine can start to draw water during the period when it is turned off. To prevent this from happening, you need to follow simple precautions:

1. First of all, you should install a faucet that regulates the water supply. It is closed every time after washing (like a tap on a gas pipeline).
2. Use an anti-siphon valve. It is needed so that waste water does not flow into the machine.
3. Lay on the floor materials that protect against leaks. They will not solve the problem completely, but they will also give their benefit.

Thus, when the washing machine draws water on its own, this clearly indicates a breakdown. First you need to accurately determine the cause, that is, establish the source of income. After that, they act according to the circumstances, if necessary, call the master.