- Reasons for performing this manipulation
- How to correctly outweigh the door
- Conclusion
Most standard models of refrigerators open the doors on the right side. However, most recently, manufacturers began to make a universal option that allows you to outweigh the doors on the other side. This made it possible to improve the ergonomic and comfortable performance of refrigerators. In this article we will describe how to outweigh the door of the refrigerator, such operations may be done by yourself at home with a minimum set of tools.
Reasons for the execution of this manipulationThe second reason,
It is easier to rearrange the door on refrigerators, in which there are two cameras. Since in single-chamber units it is necessary to perform manipulations with the freezer door. There is an opinion that after rearrangement the door closes more tightly, most likely this is due to the problems of the seal( rubber gasket), it is better to replace it, it will save you from this problem. However, the reason may be hiding in the deformation, or loose fastenings, in this case, outweighing can help.
How to correctly outweigh the door
The process of outweighing the door itself is not very complicated, in order to do this operation you will need:
- flat screwdriver;
- wrench.
However, on refrigerators from different manufacturers, the fasteners may vary, it also depends on the design of the unit itself, so the tools will need to be sized. Before starting the process, it is necessary to make sure that there are plugs and places on the opposite side of the refrigerator for fixing the swivel loops.
Now we will tell you how to outweigh the refrigerator door. First, de-energize your unit, and remove all products and shelves. The doors of the refrigerator are large and heavy in themselves, however, despite this being rather fragile, any careless actions can damage them. All work must be carried out exclusively in protective gloves. Two-chamber refrigerators have three brackets: at the top, bottom and between the doors. So, it's time to describe the process itself:
- Using a flat-head screwdriver, carefully remove the plugs from the bolts and unscrew them while holding the door so that it does not fall and do not bend the brackets.
- Clean the refrigerator door.
- Now you need to unscrew the hinges from the door itself, and install plugs in their place. Change the location of the loops to transfer them to the opposite side. Try not to touch the small parts of the hinge, otherwise it may adversely affect their performance.
- Then lift the door and start to fasten everything. It is better to start from the top, this will reduce the likelihood of loop deformation. After completing the above operations, it is necessary to adjust the hinges so that the door closes tightly.
- The last thing to do is to move the handle on the door.
Conclusion of
However, if an electronic scoreboard is provided in your refrigerator, the best solution would be to contact the master, since there you must move the cable. Try to install the door as best you can; if you install it incorrectly, it can no longer fit snugly, thereby the refrigerator compressor will start working in a more intensive mode in order to keep the cold in the chamber. However, because of this, he will quickly become worthless.
A little advice - when you rearrange the door, you need to tilt the refrigerator back slightly. Due to this, the door itself will close to the end. You can do this by adjusting the special supports at the base of the refrigerator.
In modern models, the instructions for rearrangement of the door, and some additional details are attached to the refrigerators. However, in some cases, you will need to put a few extra objects for the door. It all depends on the manufacturer.
In this article we tried to answer your question as informatively as possible how to move the refrigerator door to the other side with your own hands .
