How to bend plywood and prevent mistakes

When carrying out repairs at home, a situation may arise where it is necessary to bend the plywood sheet or its section. Basically, this occurs during the installation of arched structures or, if necessary, round corners. And here the corresponding question arises, how to perform the work on bending plywood competently and not make mistakes. Let's try to deal with this problem and describe some of the nuances of the process.

There are several ways to bend a plywood sheet. The most affordable and easiest option is to apply the soaking technique. This method also involves two different methods.

The first option involves placing a plywood sheet above a container of water, which is heated and forms a powerful steam. Due to such a steam bath, the plywood sheet is soaked. After steaming, it can be subjected to bends of the required shape.

But using this method, it is necessary to take into account some nuances. Firstly, plywood must be of good quality and from a reliable manufacturer. Poor-quality products, when steamed, can begin to delaminate or become covered with swelling bubbles.

Secondly, it is necessary to observe the time frame of the steaming process. Basically, it all depends on the thickness of the sheet and on how much, you need to bend it. With excessive steam exposure on the sheet, peeling of glued elements may occur.

The next way is to soak the plywood sheet in water. Precautions are the same as in the first method. Be sure to use quality materials and observe the timeframe for soaking. The process of softening the sheet can be controlled by periodic checks for flexibility.

The implementation of the bending of plywood sheets is carried out using special clamps or pads. Here, in fact, everything is simple, we fix the soaked sheet and wait for it to dry. When removing the clamps, the plywood will remain in the required shape.

Another very effective and quick way is to make frequent cuts on the plywood sheet. That is, we produce frequent horizontal cuts on the sheet, which will allow us to bend it into the required shape.

The only nuance that must be observed is the frequency and depth of cuts. Everything here, also depends on the amplitude of bending. The larger it is, the more often it is necessary to make cuts.

Follow the above recommendations, and this will allow you to get the desired result without any problems.