Each winner of the cabinet can not be insured by the fact that problems in it, sooner or later there will be. Therefore it is necessary to know certain nuances of operating items, such as what to do if you want to wardrobe repair, replacement of rollers and guides. On this and will be discussed in the article.
That often breaks down in a sliding wardrobe system
The content of the article
- That often breaks down in a sliding wardrobe system
- How to replace the rollers in the design
- Features of the replacement rail
- Prevention of problems
Repair-compartment cabinets, replacement of rollers in it, most often observed in people who can not be prevented. First you need to understand what causes problems exist. Above all, these include:
- Contact with various contaminants or dust accumulation device;
- Failure of the rollers;
- Wrong location mechanisms.
In any case, construction of the cabinet consists of two elements: the main part - frame, and mechanical. Thus, the problems with the first of them appear frequently. Usually, this occurs because of a long life, and resulting in small gaps between the leaves.
The problem may occur due to a high load, which takes design. In any case, with the correction of the defects is not necessary to linger.
How to replace the rollers in the design
It is believed that the defect with the rollers is the most widespread. It can be seen when there are difficulties opening the cabinet door. Previously should determine the type of product to fix the problem.
Failure can leave the upper and lower rollers. To fix the top need to do the following:
- Unscrew the screws;
- Extract the element which is damaged;
- Set the same element;
- Finally fix the delivered items.
If you are going to replace the support rollers, it is necessary to perform other actions. Namely: the removal of the valves (they are not fixed), with the help of the hexagon to unscrew adjusting bolts, replace old with new ones.
Features of the replacement rail
Changing the guide should be, if you notice that the jammed valve, being in a certain position. This fact indicates the damage. To remedy the situation, you need to start with the dismantling of the cabinet doors.
After removal of the valves should replace damaged parts and install the new ones on the right place.
ATTENTION! If you wish to fix the structure, it is recommended to put on the new rail mounting. And you can delete the original.
Prevention of problems
To prevent or eliminate some of the defects in the operation of the cabinet, it is necessary not to forget about some of the events. First, let's understand that the wardrobe is always advisable to keep clean on a regular basis to take care of him. It is necessary to get rid of the small particles, because of which may have different kinds of pollution.
Consequently, the first piece of advice would be a frequent use of the vacuum cleaner. The second - the application of a special lubricant, as the parts are subjected to constant friction and extend the life of the device is necessary. Will help to ensure a smooth slide mechanism cabinet.
In addition, it is necessary to monitor and look chipboard, of which the structure.
IMPORTANT! Positioning next to the cabinet or heating devices in high humidity can not, it may lead to deformation of its surface. It is recommended to wipe the product with soap and water, then thoroughly dry it.
