How to turn on the scanner: possible errors and difficulties when connecting the scanner.

In the process of work and study, we often use a scanner. How to connect it to a computer and what difficulties may arise in this case, we will consider in the article.

How to connect a scanner to a computer and turn it on

You can connect this device in several ways:

1. Using a USB cable and driver disk. When buying a scanner, a USB cable and a driver disk are attached to it. First you need to connect one end of the USB cable to the scanner connector, and the other to the computer connector. Then wait a few minutes until the operating system detects the device connected to it. If the equipment was not found, install the drivers and try connecting again. After installing the drivers, the “Setup Wizard” will pop up on the screen, then you will need to perform the proposed actions. Then restart the computer and scanner for further work. When finished, a shortcut to the new equipment will be installed on the desktop.
instagram viewer
2. Using a network scanner. After connecting the USB cable, select in the "Start" section "Control Panel" and "Network". In the "Network and Access Control Center" run "View Devices" and select the model of your device. Next, “Install” following the instructions provided. Then click on “Next” and “Finish”.

Further, when the computer is working with a scanner, it will not be necessary to install drivers each time. You only need to connect the cable and go to the "Settings Wizard", activating the work of the connected equipment.

IMPORTANT! If there is no driver disk, they can be easily downloaded via the Internet from the manufacturer’s official website.

Possible errors and difficulties when connecting the scanner

When connecting a scanner, it is necessary to take into account some nuances:

1. For the full operation of the scanning equipment, it is not enough just to connect it to a computer and install the driver. A large role is played by many programs for image recognition and scanning, these include: Adobe Fhotoshop, VueScan, etc. To check for compatibility of these programs with the scanning device, you must open the "File" item in the menu of each of them. Then go to the “Import” and check for the presence of a line in which the model of your equipment will be indicated.
2. When scanning the necessary documents, do not press on the cover of this device, in case it does not close. Otherwise, it can be seriously damaged. Also, handle glass with care: do not scratch, do not crush, etc.
3. If you have problems working with a scanning device that was not purchased at a store, then you must take it to a service center. The cause of the problem can be anything: the cable is loose, parts are burnt out, an error occurred while installing the drivers, etc.
4. There is also the possibility of marriage. In this case, you must contact the store where they will check the equipment for defects.

If the marriage is really detected, then in return you will receive a new scanner. If there are no factory defects, you can try installing the drivers again.