There are situations when you need to disassemble the joystick. For example, water got inside, it must be cleaned of dust and dirt, replace certain parts or just familiarize yourself with the design.
What it takes to disassemble
The content of the article
- What it takes to disassemble
- Important points
- Disassembling the xbox 360 wireless joystick: step by step
To disassemble the device, you need the following items:
- Torx screwdriver 8.
- Small Phillips screwdriver.
- Flat screwdriver (can be replaced with any flat object).
Important points
You can disassemble a gamepad yourself only if a person understands the structure, and knows what he is doing. Otherwise, there is a risk of damage to the parts of the joystick.
Reference! Sometimes it is better to contact a service center.
Disassembling the xbox 360 wireless joystick: step by step
Disassembly may be complete or partial. It all depends on the goals. For example, if you plan to repair the board, you should stop at paragraph 5.
The process of disassembling the gamepad is as follows:
- You must remove the cover from the battery compartment (located on the rear panel).
- Remove the batteries or battery.
- Unscrew the screws. Their number is 7. One closes with a sticker that will have to be torn.
- Use a flathead screwdriver to remove the back cover.
- Now the board is being removed. We fake it from the side where the headphone port is located.
- Now we take out the buttons and elastic bands. If you turn the device over, they will fall out on their own.
- To remove the cross, unscrew the screws using a Phillips screwdriver. Now remove the part with your own hands.
- To remove sticks, they must be pulled over.
- And it’s more difficult to dismantle triggers. First, they are pressed in the lower part (this can be done by pushing a small screwdriver on the inside with a screwdriver).
- Now we push the fasteners holding the button and pull out the spring.
- The last step is to tilt the key up and pull it out.
- The dismantling of the gamepad is over. You can assemble the device by performing all the steps in the reverse order. And damaged parts can be replaced during the assembly process.
Disassembling the joystick yourself is very simple, just use the instructions. But to replace parts it is better to contact a service center so as not to damage anything.