How to eliminate the smell from the sink in the kitchen? Mechanical, chemical, folk remedies

Kitchen - a place where there is delicious and mouth-watering aromas. But sometimes in the room may appear very unpleasant odors from the sewer. What to do? On the sources of the problem, the degree of its danger, how to detect and eliminate the flaw, as well as preventive measures, read on.

Causes of bad smell from the sink

Consider a situation in which there is this failure:

1. The most common one is blockage in the trapBecause over the lifetime of the device is gradually filled with all sorts of food and fat residues. Wastes should go together to the drain, but they get stuck particles and then deposited on the walls, eventually forming the layer growing.
2. Often malfunction is caused by plumbing clogging sewer pipe.
3. Next there is a defect, if the owner is a long time
   instagram viewer
   He does not use a washstand. As a result - the waste output system is not filled with fluid, which simply vanished. siphon device may be different, but the operating principle remains the same: the presence of water inside the tube, blocking the penetration of gases from the sewer pipe.
4. siphon mechanism assembled erroneously. Driving its installation is simple, because it consists of a set of ready parts, which can only properly connected. Any mistake or carelessness will lead to the fact that the water seal will not work.
5. The corrugated pipe is connected with a riser leaking. This occurs when the nozzle diameter is larger or smaller diameter, and the flutes have therebetween the gasket.
6. Sagging corrugated tube. Over time, the member may stretch or sag, resulting in disturbed draining process. Stock slack begins to stagnate in the area or the entire flows, and the water seal is not formed.
7. Damage to siphon components. After a long use or due to external influences (accidental shocks, and other damage) plastic capable of losing elasticity, covered with fissures. Pipes begin to leak, extending from the drain. The water evaporates and impregnates the walls and floor, the smell of it is preserved.
8. Air pocket in the riser can lead to malfunction.

Whether it is dangerous?

Sewer gases represent a definite threat to humans. There are three main types of gas mixtures produced on the basis of hydrogen sulfide, ammonia and methane. Hydrogen sulfide and ammoniacal compounds are accompanied by a specific odor, methane does not smell. Their long-term smokers concentration leads to deterioration of health:

• respiratory tract lesion (bronchi, lung);
• partial loss of smell;
• the effects on the nervous system (anxiety, disruption, fainting).

Diagnostics

To identify the specific cause of the problem, spend a few simple tests:

1. Let's see how fast the water is removed from the washer. If it detects a delayed run-off or absence of flow, then we deal with clogged.
2. Examine the sewer pipe, but the inspection will help only when the dirt is concentrated in the top.
3. Pay attention to the appearance of the siphon design: sealing joints, corrugated state (normal shape, no cracks), the absence of any damage to the cells. Detected shortcomings point to the depreciation of equipment, gaskets or incorrect assembly. Corrugated tube and drop into the container including water. If the drain violations there, proceed to the next step.
4. Trapped air in the system can be detected by a delayed drain and characteristic sound (bubbling).

Reference! In serious cases, call the plumber, but in most cases the defects are removed on their own.

How to get rid of the problem?

Clogged siphon can be easily cleaned of accretions. We use the most simple and accessible tool that is convenient to operate.

vantuzom

The apparatus is pressed against the drain washing, then let warm water under pressure. When the liquid reaches the top edge of the rubber cap, we press with force on the handle, making up and down movement. After the destruction of the valve plug and wash remove the remaining waste.

On a note! Simple contamination can be removed materials at hand when the hand is not the valve. For example, a milk cut angle cardboard packaging, and this part of the covered drain, and then make a few jerks.

wire rope

Clogged sewer pipe can be removed on its own, if it is located at a short distance (6 meters). Apply for work plumber's snake, at one end equipped with a handle, on the other - with a brush or hook.

Follow the procedures: Firmly hold the handle in your hand and begin to slowly rotate the device until it is able to move deeper into the pipe. When the device is rested into the blockage, break and pushes dirt on or extract them, depending on the details such as the tip of the cable.

Important! The process is complete, the tool should be washed, dried and lubricated with engine oil.

power shower

If the shell is not used for a long time, it will be enough to enable the medium pressure water to siphon device is filled with liquid. Then you need to wait until the bad smells will no longer appear.

Mount correctly siphon

Incorrectly assembled device should be disassembled and in the correct sequence (according to the manual) to connect part.

check sealing

Question for sealing between the sewer pipe and corrugated pipe is easily solved: it suffices to establish the appropriate diameter of the seal, it closes the free space through which the gases penetrate.

bellows, To change the form is returned to the correct position, fixing the position of the tape. If the item does not give in, then it is replaced with an analog.

On a note! Alternatively, you can use a rigid plastic pipe instead of the corrugations, but this method is suitable at a convenient location in the sewer pipe.

In cases where the device has been operated for a long time and it's parts is significantly worn, it is advisable to install a new instance.

Trapped air in the sewers can not be repaired in the home. The source may be located at a great distance from the shell, making it difficult to diagnose. In this situation, we need professional skills necessary to cause plumbing.

by chemical means

Against tough blockages help funds sold in stores:

1. "Mole" copes with the smells and pollution, works quickly and efficiently, for sale at an affordable price. Him kind of liquid is less invasive than pelletsAnd does not damage the plastic.
2. "Tiret" clears pipe of any type, restores the drain in a short time (5-30 min., The time determined by the complexity). Due to the safe properties of the gel, you can not wash off makeup before morning.
3. "Domestos". Its composition makes it easy to solve the underlying problem. In addition, the gel base protects the inside of the sink, forming a protective film. Created layer provides a disinfection and while blocking the waste settling on the walls.
4. "Bugs Pothan" - a powdery substance, can give the best results. The mass is filled into the hole cleaning and hot water added. The process itself takes about 3 minutes. Its drawback - the high cost. If you are using mandatory eye protection, skin, respiratory system.

Attention! All actions are performed with gloves and respirators, provide fresh air into the room.

Important! Before you work with these drugs, from washing merge the accumulated water. To the processing was qualitatively follow the directions on the label.

folk ways

There is a proven, lightweight and affordable methods used by our grandmothers.

Important! Plastic constructions are washed with hot water only. Abrupt boiled water is allowed to pour if pipes are made of steel.

1. Take a salt thereof in an amount of 100 g, and sprinkle it drain aperture. Immediately pour the heated liquid, waits for a few hours, and then washed with hot drain pressure.
2. The following procedure is best done in the evening. Salt and baking soda mixed in equal proportions, texture fill hole sinks. We pour boiled water and leave until morning.
3. By means of citric acid will be able not only to clean contaminants from the plumbing, but also flavored room. One packet substances pour into the drain, add boiling water and after 30 minutes the mixture was washed off with warm pressure.
4. Problem can be solved by using soda at the rate of 250 g per 100 ml of vinegar. Vinegar podogreem slightly in a water bath. Soda fall asleep drain and fill heated component. That the method worked, zatknom hole damp cloth. We wait till 30 minutes, pour the hot water into the sink flow and run a warm liquid.

On a note! In the latter method, instead of the usual soda convenient to use calcined equivalent. The flow rate is 2 times smaller, it has a strong properties to combat clogging.

prevention

Use measures that will save you from unnecessary problems and extend the life of your plumbing:

1. If you are a long time away from home, prior to adding the drain aperture sink a little vegetable (or machine) oil. The product forms on the surface a thin layer that prevents evaporation.
2. Each time a dishwashing rinse drain aperture jet of hot water.
3. Equip protective shell mesh, it will be delayed food residues.
4. Once a month, spend processing cleaning chemicals or traditional methods.

Most of the problems that cause bad odors in the kitchen, the owner can fix on their own. It is important to identify the cause and then fix the defect by using the most affordable and suitable manner. If you experience any difficulties please contact a sanitary service.