How to replace a light bulb in the refrigerator: return light to quickly and easily

Almost every person in the kitchen with a refrigerator. It is indispensable for food storage. The principle of operation is quite simple refrigerators. Even if you have purchased a "heaped up" technique, it is easy to manage. only need to properly connect to a power source and set the necessary settings (for the main part and the freezer compartment).

And indicators for correct operation of the refrigerator lamp is located inside the. It also makes it convenient to use the unit. But sometimes it is temporarily disconnected, flashes or even burns. So, it's time to replace the light source.

To fix the problem you need to understand exactly the reason for the lack of lighting. In this article we will share ways to diagnose and identify the causes of damage. In addition, we'll show you how to eliminate the defect and restore lighting in the refrigerator.

Checking the lamp life

Do not rush to buy a new light bulb and replace it! This may not help if the cause is not it, and disruptions in electricity and equipment. To prevent errors perform a thorough diagnosis and set the type of fault occurred.

• Check the wiring in home. Often, problems arise due to chafing or a discharge wire.
• Inspect the power outlet and the power supply. Problems may arise from the bad connection. Plug other equipment into the outlet to check its functioning.
• Make sure that the electricity is supplied to the flat as usual. You may cut electricity throughout the house? Try turning on other appliances. If they also do not work, then the reason is the absence of light.
• Observe the operation of the household appliance. Typically, refrigerators are turned off for a few minutes. This is normal operation. In the absence of light for more than 30 minutes it may be assumed that the problem is in the bulb.

If you follow all stages of instruction lamp is not lit and the refrigerator was still dark, the problem lies in the very light bulb. To resolve this problem, you need to make it a complete replacement.

IMPORTANT! Some models have features of the instrument lighting. They appear at work. Check with vendors or website with information about the product.

How to replace a light bulb in domestic refrigerators

There are various types of equipment, we shall understand how to replace in each case. To begin, consider the Soviet equipment options.

The procedure for replacement of the lamp is as follows.

• beforehand buy a bulb of the same brandThat is installed in your refrigerator.
• unplug the refrigerator from the power supply, remove the power cord.

TIP! If the work is delayed, it is better to remove all the products and defrost system. Remove all the water from the chamber.

• Disconnect protective lampshadesWithin which a bulb. Disconnect wiring suitable to head for. In the presence of the tape and remove it.

IMPORTANT! Some refrigerators plank hold by means of special clamps. Remove them easily. Pull the loose ends until it clicks, then remove the bar.

• After that Remove the light bulb from its socket and insert a new one. Then return the ceiling and all wiring to its original position.
• Turn appliances into the outlet, make sure the correct operation.

TIP! Follow replacement accurately in compliance with safety regulations. Details can be very fragile, handle with care.

How to replace the light bulb in the imported refrigerators

If you are in your home imported model, the action plan will be slightly different. These units have in their structure interesting ceiling with a complex device.

To disassemble the need to perform the following manipulations.

• Turn the power off, defrost system and remove all of the products and the obstructions that impede work.
• Find a spot lamp mounting. On top of the transparent cover can be seen a large gathering of ice.
• The lid is secured by three special retainers with clips. Minus screwdriver, pry one of the edges and lift it. Then gently disconnect the remaining holders.
• Unscrew the light bulb from its socket and make its replacement.
• Now close in reverse order and turn on the power.

With the correct replacement light should go back.

This plan is suitable for most imported products, for a detailed description read the instructions specify the details of the consultants.