Very often damage the cabinet hinges are broken, and they are difficult to fix, unless you know the instructions. In this article you will learn how to fix them quickly and easily.
How to fix a torn cabinet doors
The content of the article
- How to fix a torn cabinet doors
- What if I vomited with loops
Immediately it is worth noting that a number of defects, you can easily solve yourself. For example, the frequent situation - creaking when opening / closing. And all the doors creak in the material independence. The most unpleasant sounds publishes metal. In this case, the sound is no closet, and loops, and so they need to be repaired. You will need:
- oil. It is desirable for a special oil loops are allowed in the machine;
- syringe. No special requirements.
However, it should be borne in mind that there are some cases where a loop or replace the door is much more profitable.
Important facts. As mentioned above, the special oil for loops is more necessary for this, since it is sold in special aerosol.
Instructions for repairing the door is quite simple. Suffice it to good fluff loop, during this process, preferably one or two times to open and close it, so that the oil is better absorbed. However, if you have the engine oil, there is a little more difficult. It needs a syringe. It works with almost anyone, including diabetic. It is necessary to do all the same steps. Use only a few drops, then the excess will be different at the bottom of the cabinet.
What if I vomited with loops
It often happens that the loops come off, and they do not attach the back, because too much carving, and the screws do not hold.
For repair, you will need:
- drill 8 mm;
- PVA glue;
- dowels 88 mm.
- In the beginning you need to 8-mm drill holes for screws to increase. Importantly, this is allowed if you have used other wood in the other case, use the instructions below. The most important thing to know the measure, do not drill through. However, it should be borne in mind that the drilling depth should be greater than 10 mm.
- Take the dowels 8 mm. They need to be nailed in the resulting hole, and before that a well lubricated with glue. Try to score until the end, but be careful, because the dowel presses through the plate from the rear side without any problems. If at the end you have any acting tips, then took to drink them.
- Insert the screws into the dowels. The resulting design is safer in times previous, because the screws are fastened with great shkantami.
After that, you must wait until the glue dries and hang the door.
