After three or five years of operation of the control device, the display goes out. The most common reason for this is a discharged battery. It is enough to change the batteries in the gas meter to make it work as before. Despite the simplicity of the operation, not everyone knows what to do.
Is the date displayed on the gas meter when the batteries are replaced?
The content of the article
- Is the date displayed on the gas meter when the batteries are replaced?
- Are gas meters reset to zero when the battery is replaced?
- Gas meter: battery replacement
- Replacing the battery in the gas meter: instructions, who can change
- How to change the battery in the gas meter yourself?
A faulty screen may be due to two reasons: a dead battery and broken electronics. And if you cannot cope with the second problem on your own, then you can solve the first one without calling a qualified master, saving time and money.
Reference! If the gas meter malfunctions, the number of gas cubes spent is not counted, and charges are made at different rates, most often extortionate for residents of an ordinary apartment or house.
Even with a timely call to the gas masters, you may be charged a fee at a different rate. There is only one solution here - to fix the problem on your own immediately after its detection.
The battery usually works for the entire period between two meter checks. An early failure may be due to the fact that someone has grounded the gas pipe, which makes the battery run out faster than the designated time.
Procedure:
- Pry the seal gently with a knife. If a metal wire is sealed on it, then you cannot touch it - a fine will be charged.
- The body has special recesses. It is necessary to pry the case for them with a screwdriver, moving from top to bottom.
- Remove the battery. To do this, you can cut the wire with pliers or solder them.
- Replace the battery after paying attention to the location of the positive and negative terminals.
- Solder the new element to the break points.
Check: if the data on the display is without minus, then it is in order.
Are gas meters reset to zero when the battery is replaced?
On average, about 3 cubic meters of gas are consumed per person per month. So, two people will spend 7-8, and a family of three will spend about 10. This is provided that you live in normal conditions, without the daily "hellish kitchen".
Important! If only one person is registered in the apartment, then the installation of gas meters will be meaningless: so you will be charged for all cubes spent, not the average reading per person.
Gas meter: battery replacement
The replacement period is influenced by the supply of gas networks.
It is recommended to purchase a meter in stores specializing in them. The seller will give detailed advice on the choice of a suitable model and will provide guidance on the answers to all available questions.
After replacing the meter, it is necessary to carry out a thorough check. If the work is done with high quality, then you can sign an act of completed work. Then the device is sealed.
Important! Breaking the seal should not occur until the next verification date. For violation of this rule, residents are issued a fine.
Replacing the battery in the gas meter: instructions, who can change
When replacing, refer to the manufacturer's instruction manual. In the absence of a document on hand, it can be found on the Internet.
Important! If there is no wire seal, you can replace the power supply yourself. If available, replacement is impossible, and if traces of burglary are found, the apartment is subject to fines in the amount of up to two hundred thousand rubles.
If there is a seal, Gorgaz employees are responsible for the replacement.
- If the battery has not worked for the prescribed period (it is measured by the dates of the next two verifications) and its non-working condition is not associated with a violation of operation, then the manufacturer carries out the replacement free of charge. That is why it is better to make a purchase in specialized stores. Employees will draw up a breakdown report within the warranty period and send the device to the manufacturer for repair. In this case, you pay only for dismantling the meter and reinstalling it.
- The service life is determined by the manufacturer depending on the characteristics.
Also, if the battery fails, do not rush to contact the utility service. A complete device replacement will cost you much more than installing a new battery yourself. However, if Gorgaz refuses to change it and insists on a complete replacement, residents have the right to defend their rights in the housing inspection of the local municipality.
How to change the battery in the gas meter yourself?
You will need:
- new battery;
- soldering iron;
- rosin;
- tin solder;
- knife or screwdriver;
- tweezers.
Initially, carefully pick up the seal with a knife. Please note that it cannot be damaged. If the seal is surrounded by a sealed wire, then, we repeat, replacement is impossible in independent conditions.
The body of the device contains two recesses. Use a screwdriver to pry them: first the upper, then the lower. Remove the cover. You will see the electronic board, which will contain the battery you need to replace.
First of all, you need to solder the contacts with a soldering iron. Take out the old battery and insert a new one, fix it. Beware of prolonged interaction between the soldering iron and the contact to avoid damaging the track.
Then assemble the device in reverse order. Soldering is carried out using rosin and acid to ensure the desired temperature and cleaning of the connection.
Important! If the battery does not work, check that the positive and negative terminals are correct.. Before installing a new one, be sure to pay attention to this so as not to confuse. You can also use an electrical measuring device to determine the poles, which will determine and measure the voltage characteristic.
The technical characteristics of the new battery must be identical to the old one.
The process may vary slightly depending on the machine model. The board might be inside the cover. Then you can get to it by unscrewing the fastening screws.
A gas meter is a device, the working period of which is fixed in the documents for it. However, sometimes the screen goes blank. Most often, the reason for this is very simple - the battery has run out. This problem is solved at home without calling Gorgaz employees. The main rule is to act carefully and not to damage the seal, not to confuse the poles and be able to handle a soldering iron.
Subscribe to our Social Networks
With this method of replacing the battery, the meter will reset half of the readings. The battery must be replaced without de-energizing the old battery. Disconnect the old battery after soldering the new one
What is written here is correct in theory, in practice - sheer nonsense.
To begin with, all these counters have a factory seal, breaking which you can safely throw the counter out the window - no one will register it, and representatives of the IWG will also impose a fine. Meters with a special hatch for changing the battery have already appeared, for example, the Oryol SGMB-4, where the plant has already laid this opportunity. And it's better not to go into the rest.
absolutely agree.
this is sheer nonsense by the gray Ko ...
Which university said that the battery will quickly drain from grounding the pipe?
This is what university, such knowledge, and, accordingly, advice. After reading such "advice", people find themselves in money and problems.
Old bike. When the counters began to go out en masse, a lot of clever conjectures appeared, and the simplest - a Chinese semi-charged battery - did not come to mind.
I do not agree with the author that for the dismantling and installation of the meter under warranty, I must pay. Everything happens free of charge during the warranty period. I have personal experience with a gas meter, the battery did not finish its work on time. All work is at the expense of the manufacturer.
"An early failure may be due to the fact that someone grounded the gas pipe, which made the battery run down faster than the specified time."
The author, take the trouble to explain.
Are you familiar with electronics, and simply with electrical appliances? Where did you get such conclusions about the "drawdown" of the power supply elements of the electrical appliance when the gas pipe is grounded?
In parallel, a 3.7 volt mobile phone battery is connected to a discharged battery using wires with "crocodiles" - it is removed after 8 hours. The readings remain the same, everything works fine - tested on several meters !!!
The author proposes to break the seal and at the same time warns of a fine of 200t
