When it comes to repairing the bathroom, and especially when you have to change the system of water pipes, it all takes a lot of time and money. But it will be very disappointing if, after the manipulations are carried out, some kind of breakdown or leakage occurs. To prevent this from happening, it is necessary to provide for some nuances before starting work.

Even very novice craftsmen often decide to carry out repairs themselves, this, in fact, is not complicated, especially considering modern materials and technologies. However, in this case it is especially necessary to prepare correctly, only in this way the wiring will be performed correctly. The gasket system can be hidden and open.

Where to start
Any work should begin with planning, that is, you need to draw up a project for future wiring. Although it may seem complicated to someone at first, it is still necessary, it is thanks to it that you can conveniently and correctly position each item.

Keep in mind that if in your house the toilet and bathroom are separate from each other, that is, the bathroom is not combined, then the project must be made for both rooms, their communications are connected.

Pipe mounting methods
The wiring of plumbing pipes is carried out either in an open way - when everything is in sight, or hidden. In the case of an open, all communications are mounted on the wall, above the floor, this option is the simplest and cheapest, but at the same time the general view of the room will suffer, everything will be visible.

The main advantage of this installation method is the constant control over the state of communications. If only the slightest leak appears, it will be immediately noticed, after which measures will be taken. The most important thing in this method is to take into account the method of connecting the elements, even the most novice plumber can cope with the work.

If all communications are hidden in the wall, especially when they are plastered from above, and also closed with ceramic tiles, then it is simply impossible to detect a leak on time, in the end it will be necessary to open the wall. All this leads to additional expensive repairs, which can be avoided when the pipes are not recessed into the wall. That is why most people choose the open installation method. To mask unaesthetic pipes, various methods and designs can be used, for example, decorative panels.



-
When an adjustable floor is more profitable than a capital screed
-
What mistakes are made when the radiator is connected diagonally?
-
What are the consequences of building a site without permission?
-
What errors lead to water hammer in the heating system and how to avoid them
-
Why does the grinder work, but the disk does not spin
-
What could cause the cabinet door to bend
-
5 reasons to change the wizard without waiting for the repair to finish
-
How to cut tiles without dust
-
How to cut a fiberboard with a flat edge with a regular grinder
-
Why you should not put aluminum radiators on central heating
-
Why you can not allow for flaws in the installation of roof nodes from corrugated board
-
What boards can not be used for half-timbered
New publications are published daily on our channel in Yandex. Zen
Go to Yandex. Zen