Each house, apartment, kitchen has a special room. A feature of the kitchen room is cooking. How cooking will be quality depends on the comfort and coziness of the room. Comfort - the convenience of arranging cabinets and drawers, for kitchen utensils, the location of the sink and stove - is necessary for high-quality cooking and eating, it depends on the owner in the house. Comfort - cleanliness, complete order, deliciously cooked food - this is the face of the hostess. To achieve it, all utensils should be stored in an easily accessible place, not to be evident. Consider the most convenient ways to store plates, because we use them every day.

Plate Storage
Such a place should be at arm's length from the sink for washing dishes. This will ensure the convenience of folding dishes without unnecessary gestures. But at the same time, plates should not be stored far from the stove. The best storage option is a wall cabinet designed by the manufacturer for drying and storing dishes, located between the sink and the gas stove.

The advantages of such a cabinet are that in its internal cavity there is a metal or plastic structure that holds the plates in a vertical position. Between the design of the dryer and the lower part of the cabinet, there is a bath with low edges. It serves to collect flowing water from the dishes. Above a plate dryer, a cup dryer is usually set up.

But what if there is no special cabinet? If you have a conventional wall cabinet, it is quite possible to equip it yourself. Appliances and dryers often sell dryers for kitchen utensils. You need to choose a dryer according to the size of the wall cabinet.

Conversion of furniture with drawers
There is an option to equip furniture, with pull-out sections, for storing dishes with your own hands. To do this, you need round wooden sticks (stops) with a diameter of 2 cm. The height of the sticks should be slightly less than the height of the drawer. We put a plate on the bottom of the box, mark four points with a pencil on the outer diameter. The distance should be the same between the marks.
Then we indent 1 cm from each point to the outside of the circle and make notes for the holes. We take a drill, drill holes according to the diameter of pre-prepared self-tapping screws. We attach stops to the drilled holes vertically, and we fasten them strictly in the center of the stops with screws to the bottom of the section. We do the same with plates of other diameters. For more reliable fastening, stops, at the docking point, it is recommended to coat with glue.


The advantages of such a refinement are that the dishes, being between the stops, can no longer be damaged, for example, when the drawer is suddenly opened.



-
When an adjustable floor is more profitable than a capital screed
-
What mistakes are made when the radiator is connected diagonally?
-
What are the consequences of building a site without permission?
-
What errors lead to water hammer in the heating system and how to avoid them
-
Why does the grinder work, but the disk does not spin
-
What could cause the cabinet door to bend
-
5 reasons to change the wizard without waiting for the repair to finish
-
How to cut tiles without dust
-
How to cut a fiberboard with a flat edge with a regular grinder
-
Why you should not put aluminum radiators on central heating
-
Why you can not allow for flaws in the installation of roof nodes from corrugated board
-
What boards can not be used for half-timbered
New publications are published daily on our channel in Yandex. Zen
Go to Yandex. Zen