If the lamella by the bed is broken, can it be replaced with

Even to any of the highest quality beds has its own life. Most often, breakdowns occur with connecting parts, legs, fastenings deteriorate, or it just starts to creak strongly. Most modern beds have orthopedic mattresses, and they are not laid on a grid, as it was before, but on lamellas.

Lamellas can also become unusable for a number of reasons, but they can also be repaired or replaced, moreover, with your own hands.

Quality, size and quantity

Beds can have a different number of slats, but the more they are, the better. Each of the lamellas has a small width, and between them there is free space, which provides high-quality ventilation of the mattress. The more slats, the greater the load they can withstand.

Breakdown reasons

Lamels can become unusable for various reasons. One of the most common is too high a load, that is, they will bend in the opposite direction and soon this will lead to damage.

If poorly dried or low-quality wood was used in the production, then such lamellas will also last very short.

How to repair and replace slats

First, it is necessary to dismantle the damaged or broken bar, for this it bends until it comes out of the groove, after which it is shifted to the side.

If special holders are used to fix the lamellas, then for dismantling you will need a screwdriver, pliers and a hammer. Most likely, you will have to remove the fixing pins with pliers, and then unscrew the screws.

To replace the lamellas, it is best to use special trims, you can buy them in hardware stores. In fact, the species of wood can be any, but the main thing is that it is resilient and flexible.

If your lamellas break down approximately in the center of the bed, then you can swap them with the extreme ones, where the orthopedic effect will not be so important. This will not affect the quality of the berth. But such manipulation can be done no more than 2-3 times, otherwise the functionality of your bed will deteriorate.

Remember that the width between the lamellas should not be greater than the width of the strip itself.

In fact, it is not so difficult to restore your berth, in some cases you will have to make an effort. If you think that you can’t do it, then it’s better to turn to specialists.