Philips food processor: instructions for use and care tips – Setafi

The Philips food processor allows you to extract juices from fruits and vegetables, including hard consistency, such as beets, carrots. Before work, the device must be prepared, observing the safety regulations. Thanks to this, the Philips juicer, the instructions for which are presented below, will last much longer than the warranty period.

Preparation for work

The instruction manual for the Philips food processor begins with a description of the preparation of the tool for work. You need to act like this:

1. Rinse, rinse all parts that are removed.
2. Pull the cord out of the compartment on the back of the case.
3. Set up a juice container.
4. Place the container into which the residues are collected after squeezing, slightly tilting it forward (first put the top, then the bottom).
5. Insert the filter into the fruit juice container. Cover it with a lid and put it in place.
6. Before using the filter, you need to check its integrity. If there are even small cracks, such a part cannot be used - fragments can get into the juice.
   instagram viewer
7. Place the clips on the lid and press until it clicks.
8. Place a container for collecting juice under the spout of the device.

How to get juice

The next item in the instructions for using the Philips juicer is the process of obtaining juice. The sequence of actions is as follows:

1. Take the fruits, rinse and peel, cut into pieces and put in a container.
2. Set to low or standard speed. The first mode is suitable for harvesting juice from soft types of raw materials, for example, tomato, grape, berry. The second is from solid raw materials, such as carrots.
3. Put the raw material in the loading hole, push it closer to the rotating element using the pusher. You need to press it gently, without pressing too hard.
4. After finishing work, turn off the device and wait until the rotation stops.
5. Put the element for separating the foam, close the container. Thanks to this, after spilling, the foam will remain in the bowl.

Application Tips

To get high-quality juice and extend the life of the device, it is recommended to follow these tips:

1. Use only fresh, not dried fruits, vegetables, as they contain the maximum amount of juice.
2. Do not peel raw materials, do not peel. Only the thick rinds of raw beets, oranges, and pineapples should be removed. Thanks to the preservation of the peel, the drink will be saturated with aroma and vitamins.
3. When preparing an apple, you need to consider the variety. The more juicy the fruit, the more liquid the squeezed juice will turn out.
4. If fruits contain a lot of starch, for example, mangoes, bananas, avocados, you will not be able to get juice from them in a juicer. To do this, it is better to use a blender or different types of food processors.
5. In some cases, both fruits and greens can be used to obtain juice. These are, for example, celery and lettuce leaves.

Care Tips

Caring for the device is quite simple. The basic rule is to wash all parts immediately after use. To do this, use any liquid detergent diluted in warm water. All clogged elements are placed in a small bowl for 15 minutes, then wiped using a sponge or brush. Rinse under the tap and let dry.

You can also use a weak solution of baking soda. The tool is disassembled and the parts are allowed to lie down for 20-30 minutes. Thanks to this, the stuck parts of the cake are easier to separate. After that, pass with a sponge or brush, then rinse with water and dry.

The Philips juicer, the instructions for which are described in this article, is a fairly simple device that is comfortable to work with. However, it is important to observe basic safety precautions - make sure that the wire is intact, the plug was not in the water, and also do not touch the cutting part with your hands, even if the device disabled.