Why does the washing machine take on water all the time? Top 5 Causes of Over-Withdrawal - Setafi

Normally, the machine should draw water several times in one wash. This happens at least 2 times, since the unit first draws up liquid for washing, and then for rinsing. Therefore, if the flow is continuous, in excessive quantities, this clearly indicates a malfunction. About why the washing machine draws water all the time, and how to make repairs correctly, is described in this material.

5 reasons to keep drinking water

If the unit constantly draws water, this can happen for various reasons. The most common cases are:

1. Damage to the sensor that controls the water level (it is also called a pressure switch).
2. Inlet valve malfunction is one of the most common causes.
3. Incorrect insertion into the sewer pipe.
4. Control unit failure.
5. Violation of the integrity of the tank or other elements (holes, slots may be in the cuff, rubber hose or pipe).

Pressure switch failure

This small element detects the volume of liquid in the tank and, if necessary, signals the inlet valve, which opens to pump in new water. Moreover, the device determines the degree of fullness of the washing machine in terms of the water column.

If scale builds up, deposits form, or small debris settles on the surface, the sensor tube is clogged. As a result, it will transmit incorrect data to the electronic board of the machine. Therefore, if a blockage occurs, the unit will constantly draw water.

Inlet valve problems

Another reason is related to the improper operation of the intake valve. This element is responsible for the normal supply of a new volume of water. If it breaks, excess fluid enters. But even if the valve is working properly, and it only has a loose membrane, water will pass even when it closes.

Wrong sewer connection

If the machine was recently connected, and it began to continuously draw water, the problem is most likely due to an incorrect tie-in into the sewer pipe. In such cases, the water itself flows out of the washing machine, without the participation of the drain pump. Masters call this phenomenon "siphon effect" or "self-draining".

A number of modern models stop working, and the corresponding error code lights up on the display. It stands for insufficient volume of liquid in the tank.

Control unit failure

All modern devices are controlled by an electronic processor installed on the board. This is a mini-computer that sets the desired program and controls the wash. If the valves are damaged, the control unit stops turning them off, so water flows continuously into the tank.

If water leaks

The last 3 reasons lead to the fact that a leak is noticeable under the car. This is due to a violation of the integrity of the cuff, hoses and other elements. The situation is obvious - water constantly flows out, the required amount is not collected, so the machine pumps more and more volumes. In such cases, you must immediately stop washing, remove the cover from above and behind and find the source of the leak, guided by the traces of liquid.

What to do in case of continuous collection of water

If the cause of the breakdown is not very serious, you can fix it yourself using improvised means. You need to act like this:

1. Inspect the machine and make sure it is not leaking.
2. Carefully inspect the housing, drain hose, check them for integrity and tightness.
3. Make sure the drain hose is above the tank. It must be embedded in a siphon or sewer pipe at a height of about 50 cm above the floor. If necessary, the machine is stopped and a new connection to the sewer pipe is made.
4. If necessary, replace damaged parts with new ones.

If the reason is quite serious, it is undesirable to carry out independent repairs in the absence of appropriate skills. In some cases, you will need to call the wizard:

• intake valve failure;
• malfunction of the electronic control unit;
• crack in the hull.

In such cases, new parts are purchased, and the old ones are dismantled. But if they are to be repaired, they carry out restoration work. This decision can be made by a qualified person.

Thus, a set of excess water, especially in continuous mode, is definitely a violation in the operation of the washing machine. Some causes can be identified and eliminated on their own. If there is no exact understanding of the problem, you should contact the service center.