How to mount a ventilation facade yourself

The hinged facade can not only give the building a neat appearance, but also significantly extend its service life. Any room equipped with a facade becomes much warmer, which greatly affects the growth in popularity of this type of decoration. The essence of the ventilation façade is that under the cladding there is an air gap together with a heater, which protects the surface of the walls from the negative effects of the environment. Consider how to independently perform its installation.

In order for the design to have a sufficient level of strength, special attention must be paid to the metal profile. It must be of good quality, as well as a high level of endurance for the finishing material used. For example, for porcelain stoneware, the material will be much thicker and stronger than for facing with aluminum sheet.

The design of the ventilated facade is quite complicated, as it is presented in the form of a multilayer system, during the installation of which, even small errors can significantly reduce its service life. Therefore, compliance with the technology in the process is the key to the long-term durability of the entire cladding.

At the first stage, the mounting points of the brackets are measured and marked. Only then can you start drilling holes. Brackets are fastened using anchors with sufficient corrosion resistance. Using a screwdriver, the anchor dowels are twisted through washers. They provide a higher level of strength.

After the structure is fixed, you can proceed with the installation of the insulating layer. With the use of plastic anchors, insulation fasteners are provided. Its ply is determined based on the climatic conditions of the area in which the work is carried out. The insulation is covered by wind and a moisture-proof film so that it can protect the room not only from the temperature difference, but also from moisture. It is important to consider that the canvas should be lapped.

When all the steps are completed, you can proceed to the installation of profiles of the vertical type. Their fixation is best carried out freely so that the profiles can compensate for deformation during temperature exposure. Only after that, at the final stage is the lining itself installed.

As can be seen from the description, the procedure for self-assembly of the ventilation facade is quite simple. The main thing is that the work is carried out in absolute accordance with the technology, as well as the use of suitable related materials.