How to stick wallpaper on your own is no worse than an experienced master

In the process of repair at the moment, the most popular finishing material for the walls are wallpaper. But it is worth saying that sometimes a little experience in this matter, or complex geometry, problems with walls and other difficulties do not allow to perform the work with the highest quality. But what to do in this case, because I want the room to be ideal.

Surface preparation

Preparatory work must be given due attention, because the quality of work depends on this in the first place. It is important that the surface under the wallpaper is reliable, thoroughly cleaned, smooth and generally prepared to the maximum. It is best to finish the entire surface with putty and then prime the wall. This is the right solution, which will create a reliable basis for pasting.

At the moment, there are such wallpapers that are removed without a trace, these are non-woven wallpapers, the most common - vinyl products are distinguished by a detachable backing that stays on the wall and acts as a backing for new Wallpaper. It is important that the plaster does not fall off along with the wallpaper, this should be paid the most attention.

Pattern Fit

The modern market offers the consumer a wide variety of very different materials, which can be both with a pattern and monotonous. It is worth saying that in the case of the drawing there are additional difficulties with pasting, but on the other hand it will transform the room much better.

To fit the picture, you need to roll two rolls side by side and combine them so that the patterns match and only after that cut a piece to the required size. On the second roll, you need to mark the top and then it will protrude to drive the next roll.

What to do with glue?

After preparation, you need to proceed to gluing, and the glue must be diluted before starting work, and it is important to take into account the manufacturer's recommendations. In any case, you need to use cold and clean water, but as for the volume, this requirement is just on the product packaging.

It is best to use a roller when applying, it is a reliable tool that can be used to quickly process the entire surface. It is worth knowing that fresh glue can be easily removed and there will be no trace of it. After application, the roll is folded and let it lie there for several minutes for thorough impregnation. Next, climbing the stairs you need to deploy the roll and attach it to the wall with a small slap on the ceiling. When the upper half is adjusted according to the drawing and to the joint, it is worth smoothing the bottom, both rags and a special roller can be used.