What mistakes are often made when applying plaster

Stucco walls - one of the stages of finishing work. In the event that you do it yourself, it is important to strictly abide by the established rules and not make mistakes. About what errors can be, you will learn from this article.

1. Non-compliance with the temperature regime.

Many experts say that you need to plaster at a temperature of 5 to 25 degrees Celsius. If the room temperature is too low, the plaster will dry out longer. In addition, it will no longer have the necessary strength. At high temperature, some of the water in the prepared mixture may evaporate. This can also lead to a violation of the strength characteristics. Protect plastered walls from direct sunlight.

1. Failure of the primer.

Depending on the surface on which the plaster will be applied, the appropriate primer is selected. Violation of this rule, or a complete rejection of it, can lead to delamination and falling off of the plaster.

1. Do not help dry out.

To speed up the drying process, it is strictly forbidden to use a building hair dryer. It is also forbidden to warm the room with heaters. Remember: rushing will not lead to anything good. Protect the newly applied plaster from the draft, however, there should be optimal ventilation. The plaster should dry naturally, then in the future there will be no problems with it.

1. Incorrectly prepared solution.

During the preparation of the solution, only 2 errors can be made. The first is to pour water into the mixture. The cooking process is based on the opposite. If you fill the solution with water, then lumps are formed in it, which are difficult to dissolve. And the second is to pour the dry mixture into an already prepared solution. Develop the prepared mixture, and then re-prepare the solution.

1. Apply too thick coat of plaster.

Probably everyone wants to finish the repair as quickly as possible. In this case, a rush would not be appropriate. It is not recommended to put the putty on the walls with too thick a layer. After the first layer has dried, apply the second. The layer thickness should not be more than 3 cm.

1. Apply plaster from bottom to top.

Part of the plaster will be sprayed and fall down already onto the finished layer. As a result, you have to re-pass the wall. It may happen that the adhering particles dry out and spoil the overall picture.