How to cover a rough floor tile so that it becomes glossy

Beauty in a home is achieved in many ways. One way to make a beautiful unusual floor. For this, ceramic tile is the best suited. She is beautiful, durable and beautiful. Many lay a tile imitating a tree. And here, they run into problems. The surface of the tile is rough. Its washing takes a lot of time, it does not dry well after cleaning. You need to look for some optimal coating for the tile. In order not to spoil or change the appearance of the coating.

Opinions on this subject are different for everyone. Many say that such coverage does not exist. After analyzing all the information, you can stop on two ways.

• Tiles can be coated with special varnish. It will add gloss to the tile and remove excess roughness. Plus, varnish increases the life of the tile. There are several points, if a large number of people walk on the coating, then the varnish will wear off over time. And to remove the path that forms is very difficult. And yet, if the surface of the coating is very porous, then the varnish will have to be applied in several layers. The varnish dries quickly. Therefore, it must be applied quickly, but carefully so that the coating lays evenly everywhere. Pouring varnish into the paint tank is better in small portions, for the same reason.
  instagram viewer
• There is an opinion confirmed by the practice of many people that instead of varnish, you can use a composition for insulating concrete. It is easy to apply with a roller. It dries quickly enough. It has absolutely no smell. After its application, the tile will be protected. No scratches will appear, the pattern will be bright. The safe and easy use of such a tool puts it an order of magnitude higher than the use of varnish.

Before using any of these products, you need to thoroughly wash the surface of the coating. Let it dry and then degrease. Degreasing can be carried out using an alcohol solution or vinegar.

All compositions for coating tiles can be applied no earlier than a month after laying. Since only after a month the tile glue will surely become dry to the end. After coating with the composition, you can walk on the tile no earlier than after 24-28 hours.

After complete drying, the problems with excessive roughness of the tiles will end. Mopping the floor will be easy. It will dry in just a few minutes. And the dust on such coatings does not accumulate, since all possible pores will be covered with a new coating.