How to remove drawers from a dresser on runners: why the system is convenient

There is always a certain probability when using this or that device that it will fail. Boxes are also not considered an exception, and this is completely normal. It often happens that small objects roll into them, or the closing does not occur completely.

In any case, it is recommended to completely remove the structure. However, not everyone can do this, so this article will spell out instructions for all actions in this situation.

How to pull drawers from the dresser on runners

The whole process consists of the following simple steps:

• First you need to push the box itself to the maximum distance that it allows. On the sides are plastic mounts, you can immediately notice them. It should be remembered that since the guides are in the amount of 2 pieces, therefore, there are also 2 pieces of fasteners (one on each side);
instagram viewer
• Next, lower the small “antennae” mechanism down, then gently pull it towards you. He must go outside. There are 2 types of design. If in your case there is a symmetrical arrangement, then both parts must be omitted. Mirroring also happens. Then it is important to lower one of the "antennae" and pull the other up;
• Formed outer particles must be lowered down. They will be located both on the right side and on the left. After the described manipulations, the unit should be smoothly and without difficulty pulled out of the guides;
• And after removal, you can carry out the task for which you performed all the actions performed;
• To put the device in its original place, you must perform the entire algorithm presented, only in the reverse order. Namely: to equip the runners and push the box to the characteristic click.

REFERENCE! It is better to insert the box evenly to avoid blocking the bar, which most often contributes to the occurrence of obstacles when retracting the entire structure.

Why is the system convenient to use?

Due to its list of advantages, these models are most in demand among potential users.

1. When compared, for example, with roller mechanisms, telescopic fittings have a long service life.
2. This is because the design is resistant to stressful situations and high quality production.
3. And also she is able to withstand the most serious loads.
4. As you could already understand on the basis of the instructions, the structure is easy to use.
5. In addition, such guides cannot be installed incorrectly.
6. You can put them at a variety of heights.

Tips from experts on pulling drawers from a chest of drawers

If you encounter difficulties in performing all of the above actions at the beginning of the article, try to carefully lift the box itself to facilitate the steps in performing them. Occurrence of resistance is sometimes possible. It is then that it is advisable to push the mechanism to full stop and try to re-place it in its original position.

REFERENCE! It may happen that you have to unclip the latch along with the rubber band, but you should understand that it will eventually fly off. To obtain a glide, you can resort to special solutions that are designed specifically for this. The main thing is that their number should not be large.