How to make a wiring Stroebe no punch

Anyone who has ever faced with major repairs of their homes, or furnish new building, just aware of the complexity of the supply of communications and masking wiring. The whole process takes not only a lot of time, but also requires a certain strength and skill.

Of course, work is progressing much faster if you use professional tools. But, unfortunately, such wealth can not boast of every owner of property, and to buy expensive equipment for a single use of a few who would agree. In this case, the walls shtrobleniya fit and handy tools, which we describe below.

If you, too, will have the difficult process of laying wires and shtrobleniya channels, then take a note on these 3 simple and effective way.

A chisel and a hammer

If "home" wizard have a suitcase with the tools, there is sure to find a hammer and a chisel. These versatile tools for a variety of repairs, including for laying Stroebe.

The process itself is not tricky, but requires skill and strength of the master. On the layout of future wiring sharp edge painted on the wall mounted chisel. On the other end of it is necessary as much as possible to strike a hammer to a sharp end went inside wall. For a more accurate channel can use a hacksaw. Sharp teeth tool makes a small incision on the length of the cutting grooves. This additional marking speeds up and simplifies the process.

Electric drill

Many people confuse an electric drill with a hammer, considering these instruments identical. In fact, despite the similar appearance and working principle, they are still different decision striking force. This tool is able to facilitate the work, but it is necessary to consider some nuances.

The first caveat - this point shtroblenie. Scribed line on an electric drill holes are drilled at a distance of 1-1.5 cm. For a wide channel, you must drill holes in a staggered manner.

The second caveat is to work with concrete and brick. In this case, it is not necessary to rush to work the drill should be at low speed and periodically cool the drill in cold water.

When all the "dot trail" will be worked out, he comes to the aid of a chisel and a hammer. Several primitive movements and succumb to the pressure of the wall. The whole process is not quick, but effective and economical.

Bulgarian

Grooves made by this tool are not much different from the channels made by a professional wall chaser. They are just as smooth and neat, and the work itself is very fast and virtually no costly physically.

Principle shtrobleniya walls is simple and clear: on the marked line wiring made cuts grinder. For wide grooves cut is performed on both sides of the scribe line, and then hollowed out with a screwdriver or chisel.

The only drawback of this method - is an abundance of dust. Work with grinder in such conditions is impossible without a respirator. In addition, you will need an assistant who will work with a vacuum cleaner (building or industrial), eliminating the clutter in the immediate vicinity of the cut line, so that dust is not scattered on the premises.

The above options shtrobleniya walls for a long time tested in practice, and has repeatedly proven to be effective. Try it and you, and then the lack of punch will no longer be an obstacle in the process of repair.