5 simple tips to save the refrigerator from itself

It is difficult to find a home without a refrigerator. However, surprisingly few people know how to use it! Opening the door, taking food and closing the door is a standard instruction for its use. This, of course, is simple and effective, but it is much more useful to get to know your ice friend better. So today I will tell you how to save the refrigerator from itself and misuse.

The first step is before installation

Oddly enough, good handling of technology begins with transportation. Already at this stage, you can be stupid so that the new purchase stops working. For example, you only need to transport the refrigerator in an upright position.

When tilted, the risk of breakage increases significantly. If you lay it on its side, it is highly likely that the oil from the motor will flow into the circuit. As a result, the capillary tube becomes clogged in the first hours of operation. This in itself is bad, since there will also be no warranty repairs. In the event of malfunctions related to transportation and misuse, the manufacturer does not give guarantees.

If the refrigerator does not fit in the car in full growth, then when tilting it is necessary to ensure that the compressor tube is vertical. So the likelihood of breakage will be much less. When properly positioned, the oil will most likely return to the engine. A caring manufacturer usually writes on the box about the location of this tube.

Second step - placement

To properly install the refrigerator, you must first keep track of the distance from heating and radiators. The room (usually the kitchen) should be easily ventilated. It is not recommended to place the refrigerator next to the stove. Well, it is undesirable to install it near the windows on the south side so that direct sunlight does not fall. It is best to install where there is a draft.

Warm floors can be another problem. If they are in the kitchen, then you need to figure out how to install electrical appliances there. After all, a refrigerator placed in a too warm place will fail much faster than it should. Simply, the motor will run without interruption and sooner or later will overheat.

Third step - installation

Before releasing the movers, you need to check the coupons, equipment and performance. If something is wrong, it is better to discuss it right away. When installing, it is important to ensure that the humidity is below 80%, the room is ventilated, and the place itself is cool. If you need to install two refrigerators at once, then it is better to leave a gap between them at least the width of your palm.

Step four - cleaning and defrosting

When cleaning the refrigerator, it is important to wash both parts, but use mild detergents and a sponge (no brushes or metal scrapers). Even if the technique is with the "No frost" function. Wet cleaning is desirable at least once a month. The back wall needs to be cleaned rather to save money, as a blockage will cause too much electricity consumption, which will lead to an increase in electricity bills.

Now to defrost. To reduce the accumulation of ice, you need to monitor the tightness of the door closing. The procedure itself should be carried out several times a year (yes, this also applies to the notorious "No Frost"). However, there is no need to forcefully do something with the ice, so no burners or hammers - it will thaw out in 24 hours. Water will flow down from the bottom, so it is logical to spread rags. Among other things, do not forget to clean the radiator from dust if, like with old technology, it is in plain sight.

Step five - how to escape the heat

First, the door must be tightly closed, otherwise the load on the electronics will increase and it will fail. Secondly, with a bad (worn out) seal, the same effect will be observed. When opening the refrigerator, it is better never to touch it. Thirdly, the door itself must be closed quickly, and not kept open for several minutes. However, this is already known to everyone.

But it is also helpful to keep the refrigerator away from furniture and the sun. Even in summer, it is advisable to forget about deep freezing - this will create a harmful load. If you turn on this mode, then not for long.