How to assemble a sprayer: hydraulic, pneumatic

In a summer cottage or a personal plot there is always a need for processing plants sprayer. This device is simple in design and operation. Distinguish between pneumatic and hydraulic varieties. To understand how to assemble a sprayer for the job, you need to know what goes into its design.

Sprayer device

Elements that make up the design of garden equipment:

• working container - made of materials resistant to various chemicals;
• pump - can be pump, gasoline, powered by electricity;
• pumping chamber;
• hermetically sealed lid;
• safety valve - designed to relieve excess pressure;
• flexible hose - ready-made solution is supplied through it;
• a lever with which the drug supply is regulated;
• a rigid rod of the required length, on which the sprayers are fixed.

How to assemble a pneumatic device

The assembly sequence looks like this:

• the fire hose is going;
• a telescopic bar and a hose are attached to the opposite sides of the handle;
instagram viewer
• the intake tube is inserted into the hole on the tank - its length is adjusted if necessary;
• the hose nut is manually screwed onto the thread to the limit;
• after connecting the hose to the tank, the belt is fixed on the hinges of the latter using the buckle axis;
• the operation of the safety valve is checked - you need to lift it up several times, if the element moves freely, then everything is in order;
• the capacity of the equipment is filled with the necessary contents - for this, the pump is taken by the handle and turned away.

When pouring a solution, you need to remember that its volume should always be 1 liter less than the capacity of the tank. To ensure tightness when connecting the tank to the pump, the latter is wrapped and tightened to the limit.

Assembling the hydraulic sprayer

The process also begins with assembling and connecting the fire hose.

To work with the right hand, it is necessary to install a shaft in the pallet hole, put a washer on it. Insert a cotter pin into the shaft hole - it is fixed by fixing the shaft to the pallet. A washer is put on the connecting rod placed in the hole of the pump assembly. The connecting rod itself is secured with a cotter pin. Next, the lever is fixed - both on the shaft and on the connecting rod. Washers, cotter pins are installed. The strap is assembled and connected to sprayer. To operate with the left hand, the device is assembled in the same way, but the pump and filling units of the device are interchanged.