Error codes for dishwashers Kerting

• There is no water in the system.
• The shut-off valve is closed.
• The equipment is not connected correctly.
instagram viewer
• The solenoid valve is faulty.
• Intake filter is clogged.
• The level sensor is broken or gives incorrect readings.
• The wiring burned out.
• The electronic board is out of order.

1. Check the presence of water in the system. Wait until it appears.
2. Turn the shut-off valve, it may have been blocked.
3. Check the connection diagram of the dishwasher in the instructions. Make sure that the hoses are correctly connected.
4. Carry out the diagnosis of the intake valve: apply voltage to it. Check the electronic part with a multimeter. In case of a breakdown, replace the valve.
5. Clean the intake filter of dirt. To do this, disconnect the hose from the housing, remove the filter and rinse under the tap.
6. Examine the level sensor, measure the resistance of the contacts with a multimeter. Repair pressostat is not subject to, only replacement.
7. Sequentially inspect the internal wiring. Replace burnt elements or loops.

• The drain hose is twisted, pinched or jam-packed;
• The drainage filter is stuffed with food residues, small debris, napkins;
• the impeller of the pump is blocked;
• the drain pump is defective;
• pressure switch is not usable;
• The control module does not work correctly: a triac burned or it completely failed.

1. Unscrew the drain hose. Rinse it under the pressure of water. Make sure that it is level, without kinks.
2. Open the hopper door. Unscrew the drain filter in the drain pan. Clean the part with a brush with a detergent, rinse under the tap.
3. Remove the pump cover, inspect the impeller, remove foreign objects. To get to the pump, disassemble the dishwasher. Check the part for clogging, check the electronics with a multimeter.
4. Carry out a diagnosis and replacement of the pressure switch.
5. Examine the board. If burnt parts are visible on it, contact the master. He will restore her work.

• in the car there was a leak: the water hit the drip tray, where the float sensor worked;
• protection "Akvastop" out of order.

What to do:

1. Inspect the dishwasher's hopper, look for a leak. Check the connections of the hoses and nipples. Make sure that they do not lean over and lose their tightness. Also inspect the rubber seal on the door. Replace defective components.

2. Carry out the diagnostics of the "Aquastop" sensor. It can be located on the bottom of the machine. Mechanical protection is part of the filler hose. Therefore, if it is leaking, replace the hose completely.

• the sensor has failed;
• the wiring from the module to the sensor burned out, the connections were broken;
• burned control module.

1. Check and replace the flow sensor.
2. Diagnosis of wiring, connections. In case of insulation failure, presence of burnt parts, a new cable is installed.
3. The module is checked and replaced with a malfunction.