Power saw Makita UC4020A: instructions for using the tool – Setafi

The Makita UC4020a electric motor saw, the instructions for which are described below, is used for woodworking, for example, in construction, agriculture, and during repair work. How to use the tool correctly is described in detail in the article.

Instructions for use

Upon purchase, the saw is checked for completeness and assembled according to the instructions. Before starting work, it is recommended to run the device in, sawing wooden parts. In this case, it is necessary to make even movements, cyclically raising and lowering the handle.

During sawing, they act like this:

1. Connect the tool to a network that gives a stable voltage. If it periodically drops, the electric motor receives a large load, due to which it will not be possible to achieve the declared power.
2. Immediately before sawing, check the presence of lubrication, the correct fastening of the chain, the serviceability of the lock button, as well as the lubrication supply system.
instagram viewer
3. During work, stand on a flat surface and start sawing. The technology depends on what kind of operations are performed. So, when trimming the logs with a toothed stop, they touch the logs. The saw must be lifted simultaneously by both handles - front and rear.
4. When making a cut along the log, it is important to ensure that the tire does not contact the surface of the tree, otherwise the tool may be thrown.
5. It is important to periodically check the chain tension and not overload the saw. Therefore, you should work in cycles - sawing goes on for 40 seconds, after which there is a break for 20 seconds and then in the same rhythm.

Safety

During operation, the following rules must be observed:

1. Do not place the chain close to any surface of the body. Before starting, make sure that it does not come into contact with anything. Even the slightest oversight, distraction can lead to injury.
2. The saw is taken only with both hands - the right goes to the back handle, and the left to the front. You should not change this order, as you can get injured.
3. Goggles are put on directly during sawing, and earplugs are also stuck. Protective equipment for arms and legs, special clothing should also be used.
4. When working with a growing tree, a chain saw is not used.
5. Before starting sawing, you need to stand firmly on your feet, while the floor should not be slippery. Also, for safety reasons, it is not recommended to stand on a stepladder or a fixed ladder.
6. Another point in the instruction manual for the Makita electric saw is the need to ensure that there is no strong kickback. This is especially important when sawing boughs, cutting bushes and young trees.
7. Hands are always kept completely clean, protected from oil, grease and other fluids that reduce friction.

The instruction manual for the device is standard, the requirements are easily met even by a novice specialist. During operation, you need to be careful, while the saw must be used exclusively for its intended purpose, that is, for wooden objects. Thanks to this, it will last as long as possible.