I10 Error in Electrolux Dishwasher - Water Problems

When the Electrolux dishwasher issues an I10 error, the END indicator may flash additionally - once with a break of several seconds. What does it mean? The cause of the code on the display are problems with draining or recruiting water. The self-diagnosis system determines the type of the problem and displays the icons on the scoreboard. Decoding their values ​​will help determine the location of the malfunction. How to fix the situation and return the dishwasher working capacity, read below.

What to do to eliminate the error code

You may have incorrectly connected to the water pipe or have violated the rules of operation. For example, before loading the dishwasher "Electrolux" they forgot to clean the plates of food residues - the pieces got into the drain filter and hammered the system. Therefore, the PMM can show error 10.

It is important to carry out a preventive cleaning of the plum once or twice a month.

What should be examined first:

• whether the shut-off valve is unscrewed;
• whether there is water in the tap;
• The correct location of the inlet hose (there should be no kinks).

If everything is OK, then try resetting the DTC. Perhaps this is just a system crash:

• unplug the PMM from the network;
• wait 10-15 minutes;
• please try restarting.

Is the error on the display again? Then start troubleshooting.

Do not confuse the code value. The English letter I is not a digit 1.

Check the intake hose and filter for blockages:

• shut off the water;
• unscrew the hose fixing nut to the PMM housing;

• inspect it for debris, and also clean the flow filter.

Now you need to clean the drainage system:

1. Open the hopper door.
2. Remove the basket for the dishes.
3. At the bottom is a filter.
4. Remove it from the seat and rinse under the pressure of water.
5. Sponge the water from the container with the sponge, where the filter was located.
6. Pull the cover and open the access to the pump.
7. Feel the impeller on the blockage (previously wearing gloves). Maybe it's blocked by a foreign object.

Also, the drainage pipe is inspected and cleaned, the connection point to the sewage system is checked.

If the jets and drain systems are OK, the pressure switch is diagnosed - its electronic part is called by a multimeter. In case of malfunction, the part must be replaced.

Knowing how to eliminate the failure, you can manage on their own. The values ​​of other Electrolux errors are explained in a separate article.