| Fault designation | Symptoms and causes of failures |
| d01 | On error 01, water does not flood into the tank. May be accompanied by a failure of washing programs. Possible causes:
|
| d02 | Water does not drain from the machine. In this case, the pressure switch error occurs. Possible open circuit. If error 02 shows, you may need to clean the drain filter, repair or replace the pressure switch( level sensor, pressure sensor). In difficult cases, refer to the master. |
| d03 | What does the D 03 combination mean? It can be a breakdown of a thermal sensor, a tubular electric heater( heater), or a malfunction of an electronic module. The error is accompanied by washing in cold water. What to do:
|
| d04 | If the washing machine issued the D 04, this may indicate a breakdown of the triac of the control unit. It is necessary to replace the triac. |
| d07 | L 07 is on if the load door is not closed too tightly. Try to cover the door more tightly. It may be necessary to replace the UBL or repair( replace) the handle. The guide door could also squint. To replace( repair) the handle and guide, you will need to disassemble the hatch. |
| D10 | The machine shows the D10 on the display when there is an excess amount of water in the tank. This code indicates the failure of the water level sensor. Also, perhaps, the reason is that the water pressure in the water pipe is too strong - try to fasten the valve and start the wash again. |
| D17 | With error D17 there is a high probability that the drive belt has flown off the pulley. How to fix it yourself:
|
| D21 | When the code D21 is on the display, the software has failed. It is necessary to replace the damaged parts of the control unit or completely reinstall the board. |
| ER12 | Error ER 12 in the CM appears when there are problems with the closing of the hatch. Perhaps you need to repair or replace the UBL. |
| F01 | With code F01, no water enters the tank. To remove the error, you need to check the elements of the filler system:
|
| F02 | F02 lights up? Often this code appears if the drum stops and the waste water does not drain from it. A possible open circuit has occurred. But often in this case it helps to inspect and adjust the drain system:
|
| C03 | Code C03 lights up on the display if the drum is not rotating. Perhaps the engine of the Mabe washing machine has failed. |
| F04 | On F04 error, the washing machine does not turn on. To find out the causes of a breakdown, you need a service test and a diagnostics control board. Independent measures:
A power filter may have failed. You need to remove the top cover and replace the filter( often sold with a power cord). |
| F05-F10 | Errors, from F05 to F10, may indicate a software failure. Often with such trouble codes, repair or replacement of the controller( control unit) is required. |
If the Mabe washing machine gives an error, the first thing the user has to do is to decipher the code, determine the cause of the breakdown, find ways to solve the problem.
Many Mabe models, regardless of the type of loading - frontal or horizontal, are equipped with electronic displays and a self-diagnostic system. Finding a breakdown, it displays fault codes on the board.
Next, we will look at the main error codes, tell you what to do and how to troubleshoot the problem yourself.
Important! If the error indicates a failure in the software, it is better not to try to repair or replace the AGR control unit. These works should be entrusted to the master.
The error table of Mabe washing machines: causes, signs and remedy
. Now you know what a particular trouble code means. Often, you can reset the error yourself, simply by disabling and restarting the machine.
If a breakdown requires more drastic measures, you can repair it yourself or contact a good master.
