Is there an error in the refrigerator Gorenie? This happens when there is a problem with the system. Then the self-diagnosis displays an error code on the display, or the indicators blink on the panel. How to determine the meaning of symbols? For this there is an instruction manual, as well as our article.
DTC table Gorenje
As soon as you notice a malfunction on the scoreboard, perform a hardware reset to exclude the system failure. How to do it:
- Unplug the refrigerator from the mains for 10-15 minutes.
- Turn it on again.
- Look at the scoreboard.
Are the icons glowing? Then start decoding and troubleshooting.
Error code | What does | How to troubleshoot a problem yourself |
E2 | In EP4, the control panel does not receive the signal from the freezer compartment sensor. | The thermal sensor is diagnosed. The integrity of the wiring is checked, the contacts are tightened. If the sensor is damaged, it must be replaced. |
E4 | The EP4 block does not receive a message again, but now from the refrigerant compartment sensor. | Checking the sensor, replacing the wiring, installing a new part. |
E6 | It happens in refrigerators with one temperature sensor for two cameras. It does not signal the EP4. | Actions are the same as in previous cases. |
In the event of a breakdown, the Combustion Unit may respond by flashing the indicators.
The light bulb blinks | What happened | How to fix the problem |
3 | In the refrigerator, the NTC sensor does not work. | Inspection of parts, contacts, wiring. Install a new item if necessary. |
4 | Blinks with frequency, Hz. Fault in the temperature sensor of the freezer. | Repair and replacement. |
2 Hz. Problems with the operation of the E72 module (EEPROM). | Check for all module details. For repairs it is better to consult a specialist. | |
5 Hz. Failure of the controller or the temperature sensor of the freezer compartment. | See solution for bulb 3. | |
5 lights up constantly. | The "Fast Freeze" mode is set. | After the power is off, the light goes out. |
6 | In the freezer compartment, the temperature is higher than normal. | What to do:
|
In order to avoid trouble, follow the rules of operation:
- Install the refrigerator away from heaters, ovens.
- Connect only to a grounded outlet with an RCD.
- Once every six months, carry out defrosting and cleaning the appliance.
- Do not fill the shelves with hot food.
If you can not find the fault yourself, and the error does not disappear from the screens, contact the service center.