Find out the type of failure of the washing machine LG will help the error code on the scoreboard. If the machine is in the "Wash "Rinse "Spin" modes, displays a DE error on the display, then there are problems with locking the hatch.
For the Al Ji car without a screen, all the lamps "Temperature" - "Washing" - "Rinse" blink together (burn).
What to do in order to fix the problem
Before you look for the cause of the problem and solve the problem, try removing the error DE by simple actions:
- Press the door of the hatch more strongly, it may be loosely closed.
- Eliminate possible interference to normal fixation. Could get stuck a piece of clothing, or something prevents the patency of the tongue of the door.
- The door may be skewed. If this is so, you need to tighten the side hinges.
- Do several times reset the eraser to reset the error, which means completely de-energize the device for 20 minutes, then connect to the network.
The error code DE again burns on the washing machine LG? Let's see what it means.
Signs of breakage and repair
How to fix the breakdown and fix the DE1 error on the LG Stalk:
| Symptoms of the problem | Reason for occurrence | What to do |
| The door closes, but the mechanism is not fixed. | Breakage or wear of the lock hook. | Replace the item. |
| The door closed, locked, but the washing does not start, the CM issues a DE fault. | The interlocking device (UBL) is out of order. The lock is not locked, so the program does not turn on. | Replace the locking device. |
| Operation in the washing, rinsing, spinning is stopped, error DE is displayed. Feels the smell of burning, and also the "Castle" light can shine. | Problems with the control unit. | It is necessary to check the control module. In case of damage, the connectors must be cleaned and the contacts sealed. If the card is not repairable, replacement will help. |
| The handle does not work, the door does not close. Error DE was displayed. | The handle broke. | Installing a new pen. |
| The hatch of LG washing machine is not closed due to the wear of the hinges. | The loop is damaged. | If adjustment does not help, the loops need a replacement. |
To clear the error, you need to check the specified cause of the problem. If you are sure of the correct operation of UBL, then be sure to inspect a small fee. It is located in the control module and controls the switching on and off of the Lji washing machine.
- Unscrew the screws and remove the front panel of the machine.
- Remove the bolts from the control module and remove it.
- Open the cover.
- Under the plastic you will see a small fee. Inspect it for damage. If there are burnt tracks, they need to be cleaned.
After installing the unit in place, check the operation of the washer. If the error is not displayed, and the LG machine is working properly, then you did it right.
.
