Error Codes washing machine Electrolux( Electrolux)

E10

E11

• Lack of pressure in the water supply.
• Clogged bay system.
• Input valve malfunction.
• Breakdown of the triac module.

1. Check the pressure in the water supply.
2. Inspect the intake hose. Perhaps he passed on.
3. Check the inlet valve windings. Replace if faulty.
4. Examine the control module.

E20

E21( on some C2 models)

• There is a blockage in the drain system.
• Pump malfunction.
• The electronic unit has failed.

1. Clean the drain pipe, filter, pump from clogging.
2. Test the pump winding, replace if necessary.
3. Inspect the control board.

A control module is being tested to solve the problem.

Installs a serviceable triac.

• pressure sensor failure;
• violation in the filler system.

1. Water is missing.
2. Blockage in the water intake system.
3. Breakdown of the pressure sensor( pressure switch).

1. Turn off the stop valve, make sure that water is present.
2. Clean the filler hose and filter screen.
3. Clean pressure sensor tubing, replace.

1. Check the mains voltage.
2. Clean sensor tubes from clogging, replace in case of malfunction.

1. Inspection pressostat.
2. Installing a serviceable item.

• check the tube level switch,
• clearing clogging,
• replacing it.

Violation of the Hall Sensor retaining washer - probably, it jumped off.

Sensor malfunction.

1. Installing the washer in place.
2. Installing a new tachogenerator.

Repair wiring.

Inspecting the engine, installing a new part.

1. Check and install new wiring.
2. Replacing the washing machine electric motor.
3. Reinstall electronic circuit board.

1. Change of wiring.
2. Module Inspection and Repair.
3. Change of engine CM in case of malfunction.

• violation of the control circuit;
• faulty tachometer;
• breakdown;drive motor;
• electronic module faults.

1. Check and change wiring.
2. Installing a new tachometer.
3. Change of motor CMA.
4. Repair of an electronic payment.

Launch self-diagnostic AGR Electrolux. In normal mode, the code can not be displayed.

The water did not have time to warm up in the allotted time.

• Breakdown of the TENA temperature sensor.
• Fault in the heater.

1. Thermistor check. Installing a serviceable item.
2. Testing TENA for damage and breakdown. Change parts.

• short-circuit temperature sensor or its contacts.
• Breakdown on the casing of the heating element.

A malfunction code occurs only in AGR test mode.

The electronic unit has failed.

The recirculation pump is out of order.

Failure thyristor electronic module.

E91

E92

Examination of the circuit board contacts and

EEPROM.Control of power of non-volatile memory.

EA1

EA3

1. DSP failure.
2. Disconnected DSP motor.

1. Replacing the electronic module.
2. Connection control.
3. Installing a new drive belt.

EA4

EA5

1. Repair of the connecting circuit.
2. Reinstall module.
3. DSP Replacement.

1. Close the drum.
2. Install a new belt.
3. Change DSP.

EBE

ENE

EVF

EHF

1. Cleaning the drain hose and filter.
2. Pump change.

1. Cleaning the drain system.
2. Control the use of detergent.
3. Diagnostics of the drain pump.

1. Repair wiring.
2. Installation of a serviceable pump.

1. Network Check.
2. Repair of an electronic payment.