Error 5D, SUD, SD in the Samsung washing machine

If you notice code 5D, SUD, SD during washing, it means that the level of foam in the washing machine is exceeded. You can see it in the drum or outside the machine - on the powder tray.

Material content:

• 1 What does the 5D error say
• 2 Why the
• 3 error occurs What to do to fix the problem yourself
• 4 When you need to call the

wizard What does the 5D error say

The models of erasers Samsung are equipped with a foam control function. If it becomes a lot, the machine goes into a mode that promotes the suppression of foam. The resulting 5D error indicates the impossibility of reducing the volume of foam - the washer waits for the foam to settle naturally. This deposition of foam usually lasts a long time, and depends on the concentration of the powder diluted in water.

All three codes - 5D, SUD, SD - denote the same fault. The designation depends on the machine model.

. Why an

error occurs? If a SUD error has occurred, you must first find out the cause of the problem. Such code appears if:

• A powder that is not suitable for automatic machines was used for washing;
• An overly concentrated powder was used, which the machine-machine could not cope with the foam;
• A poor quality powder was used;
• The detergent dose was exceeded for one wash cycle;
• Foam sensor has become unusable;
• Broken water level sensor;
• The water drainage hose, branch pipe, sewage system are clogged;
• A serious malfunction of the control unit occurred( but the eraser shows a 5D error for this reason very rarely).

First check the laundry detergent - often replacing it is enough to solve the problem.

What to do to fix the problem with your own hands

If the Samsung washing machine issues a 5D code when washing and the volume of foam in the drum is large, you should take the following actions:

1. Wait a little for the deposition of foam. Washing will automatically resume after that. Some models of Samsung erasers require you to press the wash button;
2. At the end of the wash cycle, clean the drain filter;
3. Remove residual powder, for which you need to start the washing machine without laundry, choosing a long wash and high temperature;
4. Change powder to another with a large amount of foam in the drum.

And here is what to do when there is no foam in the drum when flashing the code:

1. Disable the machine;
2. Get underwear. With the door locked, drain the water through the emergency drain;
3. Clean the drain filter;
4. Start the machine to check the result by selecting the previous mode.

Thoroughly clean the drain and drum from powder residues.

When you need to call the

wizard To solve the problem, you need to involve a professional if:

1. The SD error on the display did not disappear, and there is no foam in the drum. The cause may be a foam sensor malfunction. It is necessary to replace the sensor.
2. Error 5D is lit after the launch of the Samsung washing machine or during the washing process, which stops after the code jumps out. The reason is a breakdown in the water level sensor. It is necessary to replace it.
3. The Washer Machine discharges water without powder for a long time, and gives an error with the powder. The reason is garbage clogged in the hose nozzle for draining or sewage. To remove the error, you need to clean them.
4. When starting the washer, wash or rinse, error 5D lights up. Sometimes it indicates a malfunction of the control unit. Most often need a replacement unit.

Resetting errors from the Samsung SM display is sometimes done by simply pressing the “Start” button after settling the foam from the detergent.

. If all the proposed measures did not help to correct the operation of the washing machine, contact the repairman.