Dishwasher flows - water from under the door, bottom

click fraud protection

We went into the kitchen, and water flows from the dishwasher? What happened, why the leak sensor did not work? The main thing - do not panic and act consistently. We will tell you what actions to take to quickly and without damage to eliminate the damage with their own hands.

Be careful! First of all, unplug the equipment from the network, try not to step in a puddle of water. If this is not possible, disable the automat.

Material content:

  • 1 Finding causes of leaks
  • 2 Repairing leaks in the office of graphics
    • 2.1 Replacing the seal
    • 2.2 Checking the connections
    • 2.3 Replacing the sprayer
    • 2.3 For example, if PMM Bosch flows, E15 will be displayed on the screen. But this is the case if it is equipped with the Aquastop system. Deciphering the code will help determine what happened to the malfunction and how to deal with it.

      If the drips of water below are small, it is probably a matter of condensate. At the end of the sink, condensation forms on the inside of the hopper door. The rapid opening of the door, immediately after stopping the machine, leads to the dripping of moisture to the floor. Therefore, it is advisable to wait until the temperature in the chamber decreases.

      instagram viewer

      If you urgently need to open the door and take out the dishes, wipe the inside panel with a dry hoe.

      The reason for the leakage of water in the Electrolux dishwasher may be an excess of detergent or unsuitable powder, which gives a lot of foam. Start the machine with antinucipine - it will help eliminate residues.

      Open the door of the bunker and look inside. If the water exceeds the permissible level, then the problem with the pressure switch. Install the equipment on a level, otherwise water will flow out when tilted forward.

      Untimely cleaning of the seal can also lead to a similar problem. The remains of fat and food do not allow rubber to fit snugly to the body. You can replace the seal yourself.

      Noticed a major leak from the dishwasher? Then check:

      1. Drain hose and pipe connections.
      2. Problems with inlet valve or hose.
      3. Pallet Mounts.
      4. Sprinkler installation.

      Consider how to fix the problem with your own hands.

      Eliminating leaks in the dishwasher

      Decide which side of the water flowed: from below or from under the door. You need to understand the reason why the machine throws off water. Then proceed to repair.

      Replacing the seal

      Changing the rubber gasket on the door is not difficult even for a beginner. If you find that old tires have worn out, buy a new one for your dishwasher. For "Ariston", "Electrolux", "Bosch" and other brands are different gaskets.

      What should be done:

      • open the door of the bunker;
      • remove the old seal around the perimeter;
      • pave a new;if the product is too long, cut it with scissors.

      There is also a seal under the door. It will take more time to replace it:

      • remove the screws around the door from the inside;
      • remove the front panel;
      • again open the door and remove the lower basket for dishes;
      • under the door is a seal - get it;
      • install a new gasket so that the edges do not extend beyond the tank;
      • screw the panel into place.

      Checking connections

      The cause of water leakage from the pallet could be blockages in the drain system. Begin inspection with a drain hose and sewer. See if the water is running out normally, whether the joints are strong.

      Clean your drain filter:

      • open the door of the bunker;
      • filter is located below in the pan;
      • pull it out and rinse it under the tap, you can use a brush to clean it.

      Preventive cleaning of seals and dishwasher filters should be carried out twice a month.

      Disconnect the water inlet hose and inspect the inlet valve. If rust has been found on its structure, replace the part. Check the mechanical part and the holes for blockage.

      To check the connections, you will have to open access to the bottom of the equipment. To do this, unplug the machine from the communications, put it on the back wall:

      1. . Unscrew the bolts or open the latches on the perimeter of the bottom panel.

        Be careful! Under the cover is a water leakage sensor, the float of which is made of a piece of foam. Immediately you need to disconnect its contacts.

      2. After gaining access to parts, inspect the connections for integrity, and their connections for strength.
      3. If the pressure switch in your model is under( or behind), disconnect the hoses leading to it.
      4. Unclip the wiring and remove the sensor from the housing.

      The level sensor is scanned for blockage, and the contacts are called by a multimeter. In case of malfunction of the pressure switch, a new part is installed.

      Replacing the sprinkler

      Over time, the sprinkler elements may wear out. Under a large pressure of water, a crack appears in the lower part, which causes the jet to hit the door and a leak occurs, or it penetrates into the pan, which causes the water to appear under the dishwasher.

      What to do:

      • remove the bottom basket;
      • pull the lower arm out by squeezing the latches;
      • install new item.

      When the dishwasher lasts a very long time, the cause of the leakage may be a crack in the tank. You do not solve this problem yourself, repair in the workshop will also be too expensive. In this case, it is better to buy a new dishwasher.

      Listening to our recommendations, you can quickly eliminate the leak in the car and continue operation.

      Watch a video on

Why the dishwasher does not turn off, what should I do?

Why the dishwasher does not turn off, what should I do?Malfunctions

Why does not the dishwasher turn off? It does not have to be a serious breakdown. But if the work of the dishwasher can only be stopped by disconnection from the network, it is urgent to look for t...

Read More
Why the dishwasher does not close

Why the dishwasher does not closeMalfunctions

Do not close the dishwasher? You loaded the dishes, put the detergent, started closing the door, but it does not fit tightly? Another situation: the lock is not locked and washing does not begin. T...

Read More
Repair of dishwasher fault LG

Repair of dishwasher fault LGMalfunctions

The company LG produces modern technology, which is equipped with the latest developments and technologies. The dishwasher was no exception, but despite the quality, it is susceptible to breakage. ...

Read More
Instagram story viewer